CTCSS and DCS begins flashing in display.
The scanner starts searching for an associated CTCSS tone or CDCSS tone when it stops on a transmission. All tones are checked if the transmission is long enough.
However, if you press 
,and there is break before a tone is identified, the tone search starts where it left off when the transmission begins again.
3.If a CTCSS tone is found, the tone begins flashing in the display.
4.Press 
to program the tone with the frequency stored in the channel.
--OR
Send the frequency with its associated tone to another channel.
For information about sending a frequency to another channel, see Programming Channels on the page 19.
5.Restart the search and repeat Steps 3 - 4 to search for tones associated with other frequencies in the search range you set in Step 1.
34