
Troubleshooting
If your SC200 is not performing properly, try the following steps.
PROBLEM |
| SOLUTION |
|
| |
Scanner won’t work. | 1. Check the connections at both | |
|
| ends of the AC Adapter. |
| 2. | Turn on the wall switch of your |
|
| room. You could be using an |
|
| outlet controlled by the wall |
|
| switch. |
| 3. | Move the AC Adapter to |
|
| another wall outlet or replace |
|
| the battery pack. |
Improper reception. | 1. Check the antenna connection | |
|
| or move and reposition the |
|
| antenna. |
| 2. | Move the scanner. |
| 3. | You may be in a remote area |
|
| which could require an optional |
|
| |
|
| Check with your dealer or local |
|
| electronics store. |
Scan won’t stop. | 1. Adjust squelch | |
|
| to page17 setting the squelch. |
2.Check the antenna connection.
3.Check to see if may of the channels are locked out. If so, the scanner has less chance of finding an active channel.
4.Review each channel’s frequency to see if it is still stored in memory and is correct.
5.It’s possible that none of the programmed frequencies are currently active.
Scan won’t start. | 1. Press the | key again. |
2.Adjust the SQUELCH control.
3.Check to see if all channels are locked out.
Weather Scan won’t | 1. | Adjust squelch |
work. |
| to page 17 setting the squelch. |
| 2. | Check the antenna. |
54