Panasonic PT-D7600U Projection, Powering up the projector, Making adjustment and selection

Projection
		AUTO	ON POWER OFF
		SETUP			AUTO
					SETUP
			RGB	RGB	AUX
			1	2
RGB 1	RGB 2	AUX			SHUTTER
			VIDEO	S-VIDEO	SHUT
			MENU	FREEZE
VIDEO	S-VIDEO	SHUTTER
				PAGE UP
	LENS			ENTER
MENU		ENTER
				PAGE DOWN
				ON SCREEN
		1	STD	2 OSD	3 SYSTEMSEL
				D.ZOOM
		4	FUNC	5	6
			1
				BRIGHT	CONTRAST
		7 LENS		8	9
			NEXT	ASPECT	0 USER
			LIGHT	ID ALL	ID SET
		Computer			LASER ON/OFF
					Projector
			Numetric

Powering up the projector

Connect the supplied power cable. (120 V AC, 50 Hz/60 Hz)

Press the “I” marked side of the MAIN POWER switch to turn on the power.

The power indicator lamp on the projector will flash in red. After a short period, the indicator will illuminate and the projector will enter standby mode.

Press the “l” button. [on the main unit or the remote control]

The power indicator lamp illuminates in green and soon the image is projected on the screen.

Making adjustment and selection

Roughly adjust the focus of the lens. (Refer to page 41.)

Press the LENS button on the main unit or the remote control unit to display a focus adjustment

screen. Pressing buttons to adjust the image into focus.

Select and set the projection scheme. (Refer to page 71.)

Select the input signal by pressing the input selector button to toggle through RGB1, RGB2, VIDEO, S-VIDEO and AUX. [on the main unit or the remote control]

Adjust the tilt of the main unit in front and rear or right and left.

(Refer to page 18.)

Press the LENS button two or three times to adjust the lens shift. (Refer to page 41.)

Press the AUTO SETUP button if the input signal is RGB signal. [on the main unit or the remote control]

Fit the image size to the screen size. (Refer to page 41.)

Press the LENS button twice and adjust the zoom of the lens on the lens zoom adjustment menu.

Press the LENS button and adjust the focus of the lens on the lens focus adjustment menu.

Display the zoom adjustment menu again and adjust the zoom of the lens to fit the image size to the screen size. (Refer to page 41.)

Note

•If the projector is powered up at about 0˚C, a warm- up period of approximately five minutes may be necessary to start projection.

The temperature monitor (TEMP) lamp flashes during the warm-up period.

When the warm-up is completed, the temperature monitor (TEMP) lamp turns off and the image is projected on the screen.

•If the surrounding temperature is very low and the warm-up period exceeds five minutes, the control determines it as an abnormal condition and turns off the power automatically. If this happens, raise the surrounding temperature to 0°C or higher and then turn the main power “on” and turn the power “on” ().

•The AUX button is disabled when an optional input module is not connected.

•When the lamp illuminates, the lamp power mode is set to “HIGH” for about two minutes to bring the lamp into a stable condition in a short time.

39