Adjusting the position
Adjusting the input resolution
Input resolution adjustment achieves the best image when the screen flickers or halo is observed around the contour.
Procedure of adjustment
MAIN MENU
PICTURE
POSITION
LANGUAGE
OPTION
TEST PATTERN
SIGNAL LIST
:MENU SELECT
ENTER:SUB MENU
POSITION
SHIFT
SIZEDEFAULT
BLANKING
CLOCK PHASE0
INPUT RESOLUTION
CLAMP POSITION
KEYSTONE
EDGE BLENDING
:MENU SELECT
ENTER: SUB MENU
INPUT RESOLUTION
TOTAL DOTS | 1056 |
DISPLAY DOTS | 832 |
TOTAL LINES | 666 |
DISPLAY LINES | 624 |
:MENU SELECT 
:ADJUST
Press the “MENU” button.
The MAIN MENU screen will be displayed.
Select the “POSITION” with the buttons.
Press the “ENTER” button.
The POSITION screen will be displayed.
Select “INPUT RESOLUTION” with the 
buttons.
Press the “ENTER” button.
The INPUT RESOLUTION screen will be displayed.
Select one of the following items with
the 
buttons and adjust it with the 
buttons.
“TOTAL DOTS”, “DISPLAYED DOTS”, “TOTAL LINES” and “DISPLAYED LINES”
Each item automatically displays a value in response to the type of the input signal. If vertical stripes appear on the screen or the image is partly missing, increase or decrease the displayed value while observing the screen to achieve the optimal value.
Note • The abovementioned vertical stripes will not appear on the screen when all signals are input.
•The picture may be distorted during the adjusting operation, but this is not a fault.
•The input resolution can be adjusted only when RGB signal input is applied with RGB1, RGB2 IN, and the analog RGB input module (optional:
62