Registration of input signal data
The input signal data must be registered because it is not registered on shipment of the projector.
Note • Up to 96 input signals can be registered.
•Registration is performed by supplying the signal that corresponds to the mounted input module.
Registration of new data
When a new signal is supplied, press the MENU button on the remote control or operating section of the main unit, and a “NEW SIGNAL INPUTS” screen appears.
NEW SIGNAL INPUTS.
REGISTER? |
|
NAME: |
|
MEMORY NO: | – – |
S.S.NO: | – – – |
INPUT NO: | VIDEO |
fH: | 15.73kHz |
fV: | 59.94Hz |
FORMAT: | NTSC |
ENTER:EXECUTE MENU:ESC
RENAME |
|
|
NAME: |
| |
M | ||
MEMORY NO: | A1 | |
S.S.NO: | – – | |
INPUT NO: | RGB1 | |
fH: | 15.73kHz | |
fV: | 59.94Hz | |
SYNC. STATE: H(POS) | ||
| V(POS) | |
:NEXT FIGURE | :FONT SELECT ENTER:SET MENU:ESC | |
|
|
|
Press the “MENU” button.
The “NEW SIGNAL INPUT” screen will be displayed.
Press the ENTER button.
The “RENAME” screen will be displayed.
Note • The name of input signal, memory No., signal selector input No., input terminal, frequency, synchronization signal and other data are automatically identified and displayed.
• For memory numbers, 12 pages are available (eight pieces of data can be registered on each page, from A to L) and the lowest unused number in the memory will be shown automatically. If the memory has no vacancy, use the overwriting registration procedure described on the next page. (Refer to page 45)
• The registration name (NAME) will be automatically shown by the signal name and memory number.
When using the registration name automatically shown,
press the ENTER button.
This completes the registration and returns to the “MAIN MENU” screen.
To change the registration name,
select characters one by one with the
and 
buttons and press the 
and 
buttons to fix the characters or
numbers (to delete the automatically shown name, press the STD button) and press the ENTER button when the name is changed successfully.
This completes the registration and returns to the MENU screen.
Note • If you press the MENU button instead of the ENTER button, the new name to which you tried to change will not be registered but the signal name automatically shown will be registered.
44