Replacement of lamp unit
8.Insert the power cord plug into the wall outlet and then press the MAIN POWER switch.
Caution • If the power does not turn on (power indicator lamp (red) does not turn on) even after turning the MAIN POWER switch “I”, turn the MAIN POWER “O”, confirm that the lamp unit and door are installed correctly, and turn on again.
9. Press the “I” (POWER) button so that a picture is projected onto the screen.
10.Press the “MENU” button to display
the MAIN MENU screen, and then press the 
and 
buttons to move the cursor to select “OPTION”.
MAIN MENU
PICTURE
POSITION
LANGUAGE
OPTION
TEST PATTERN
SIGNAL LIST
:MENU SELECT ENTER:SUB MENU
11.Press the “ENTER” button to display
the “OPTION” screen, and then use the 
and 
buttons to select “LAMP1 RUNTIME” or “LAMP2 RUNTIME”.
12.Press and hold the “ENTER” button on the projector or the remote control
for approximately 3 seconds.
An item “LAMP RESET” will be added.
Note • When you press the “MENU” button, the lamp reset display disappears.
13. Press the 
and 
buttons to select for replacement lamp setting.
LAMP1: Replace the LAMP UNIT 1
LAMP2: Replace the LAMP UNIT 2
DUAL: Replace the LAMP UNIT 1 & LAMP UNIT 2
14.Press the “ENTER” button. When “OK?” is displayed, press the
“ENTER” button.
The used hours of the specified lamp unit will be reset to zero.
OPTION
| ID | 2 |
|
| SETTING |
| |
| LAMP1 RUNTIME | 1310h |
|
| LAMP2 RUNTIME | 1310h |
|
| LAMP SELECT | DUAL |
|
| LAMP POWER | HIGH |
|
| LAMP COOLING TIME | SHORT |
|
| RS232C SETTING |
|
|
| RGB2 SELECT | RGB1 OUT |
|
| OSD POSITION | 1 |
|
| :MENU SELECT |
|
|
ENTER:INITIALIZE |
|
| |
|
|
|
|
|
|
|
|
OPTION |
|
| |
| ID | 2 |
|
| SETTING |
| |
| LAMP1 RUNTIME | 1310h |
|
| LAMP2 RUNTIME | 1310h |
|
| LAMP RESET | DUAL |
|
| LAMP SELECT | DUAL |
|
| LAMP POWER | HIGH |
|
| LAMP COOLING TIME | SHORT |
|
| RS232C SETTING |
|
|
| RGB2 SELECT | RGB1 OUT |
|
:NENU SELECT
:CHANGE ENTER:EXECUTE
OPTION | OK? | |
| ID | 2 |
| SETTING | |
| LAMP1 RUNTIME | 1310h |
| LAMP2 RUNTIME | 1310h |
| LAMP RESET | DUAL |
| LAMP SELECT | DUAL |
| LAMP POWER | HIGH |
| LAMP COOLING TIME | SHORT |
| RS232C SETTING |
|
| RGB2 SELECT | RGB1 OUT |
ENTER:EXECUTE MENU:ESC
98