Nortel Networks 600r manual Front panel, Power button NMI button not used Reset button ID button

Page 14

14Chapter 2 600r server description

Figure 1

Front panel

The following diagram shows the front panel controls and status LEDs. For more information about the front panel controls and status LEDs, see CallPilot 600r Server Maintenance and Diagnostics (NN44200-703.)

Figure 2

Front panel control switches and status LEDs

Note: The faults described in the following table are hardware faults and are independent of CallPilot application faults.

Table 1

Front panel

Label	Description	Label	Description

A	Power button	M	NMI button (not used)

B	Reset button	L	ID button

Nortel CallPilot

600r Server Hardware Installation

NN44200-307 01.03 Standard

5.014 May 2008

Copyright © 2007-2008, Nortel Networks

Image 14

Contents 600r Server Hardware Installation Trademarks Japan Vcci statement Information for JapanJapan Denan statement Page March Publication HistoryMay Publication History Contents Contents Getting help from the Nortel Web site Chapter How to get helpGetting help over the phone from a Nortel Solutions Center Getting help through a Nortel distributor or reseller This chapter Chapter 600r server descriptionConventions for Warnings Server features Server dimensionsEnvironmental speciﬁcations Front panel featuresSpecification Environmental conditionPower button NMI button not used Reset button ID button Front panelRear panel Label Description Rear panel controls and featuresLabel Description Network connectivity PCI riser assemblyPCI riser assembly Sample network setup with Meridian Sample network setup MeridianSample network setup Communication Server Sample network setup with Communication ServerSwitch connectivity LAN connectivityNetwork requirements Remote access connectivitySupported peripheral devices Supported peripheral devices Device DescriptionReference documents Installation checklist Chapter Preparing for installationInstallation overview IntroductionGlobal CallPilot Support for Anti-Virus To unpack the equipment What is next?Unpacking the 600r server To replace the server cover Inspecting the interior of serverTo remove the server cover Inspecting the interior of server Preparing for installation Chapter Installing the server and peripheral devices Installing the serverRear panel connectors Connecting peripherals to the serverTo install the server Rear panel Rear panel connectors Label Description To connect the mouse, keyboard, and monitor to the serverTo connect the modem to the server To connect the external Scsi tape driveScsi tape drive with terminator Connecting the server to the Elan subnet If the server Then Connecting the server to the Nortel server subnet optionalMedia Access Control address Installing the Nortel software feature dongle To connect the server to the Nortel server subnetTo install the software feature dongle Dongle plugged in to serverDongle without feature key Installing the software feature keyContinue with Connecting the server to power Installing the server and peripheral devices Locating the power supply modules Chapter Connecting the server to powerSafety precautions Safety informationRack power and grounding Connecting the server to powerAbout the power supply module Before you beginConnecting the server to power To connect the 600r server to power Example setup of 600r with peripheralsWhat is next? Connecting the server to power Chapter EMC emission level protection for the 600r server Ferrite cores secured to an external cable Symbols/Numerics IndexIndex Index Index Page 600r Server Hardware Installation