Nortel Networks 600r manual Inspecting the interior of server

Page 25

Inspecting the interior of server 25

What is next?

Continue with the hardware installation, Chapter 4 "Installing the server and peripheral devices" (page 27). Or, for more information, see "Installation overview" (page 21).

Nortel CallPilot

600r Server Hardware Installation

NN44200-307 01.03 Standard

5.014 May 2008

Copyright © 2007-2008, Nortel Networks

Image 25

Contents 600r Server Hardware Installation Trademarks Japan Denan statement Information for JapanJapan Vcci statement Page May Publication HistoryMarch Publication History Contents Contents Getting help over the phone from a Nortel Solutions Center Chapter How to get helpGetting help from the Nortel Web site Getting help through a Nortel distributor or reseller Conventions for Warnings Chapter 600r server descriptionThis chapter Server dimensions Server featuresSpecification Front panel featuresEnvironmental speciﬁcations Environmental conditionFront panel Power button NMI button not used Reset button ID buttonLabel Description Rear panel controls and featuresRear panel Label Description PCI riser assembly PCI riser assemblyNetwork connectivity Sample network setup Communication Server Sample network setup MeridianSample network setup with Meridian Sample network setup with Communication ServerLAN connectivity Switch connectivitySupported peripheral devices Remote access connectivityNetwork requirements Supported peripheral devices Device DescriptionReference documents Installation overview Chapter Preparing for installationInstallation checklist Introduction Global CallPilot Support for Anti-Virus Unpacking the 600r server What is next?To unpack the equipment To remove the server cover Inspecting the interior of serverTo replace the server cover Inspecting the interior of server Preparing for installation Installing the server Chapter Installing the server and peripheral devicesTo install the server Connecting peripherals to the serverRear panel connectors To connect the mouse, keyboard, and monitor to the server Rear panel Rear panel connectors Label DescriptionTo connect the external Scsi tape drive To connect the modem to the serverScsi tape drive with terminator Connecting the server to the Elan subnet Media Access Control address Connecting the server to the Nortel server subnet optionalIf the server Then To connect the server to the Nortel server subnet Installing the Nortel software feature dongleDongle plugged in to server To install the software feature dongleInstalling the software feature key Dongle without feature keyContinue with Connecting the server to power Installing the server and peripheral devices Safety precautions Chapter Connecting the server to powerLocating the power supply modules Safety informationAbout the power supply module Connecting the server to powerRack power and grounding Before you beginConnecting the server to power Example setup of 600r with peripherals To connect the 600r server to powerWhat is next? Connecting the server to power Chapter EMC emission level protection for the 600r server Ferrite cores secured to an external cable Index Symbols/NumericsIndex Index Index Page 600r Server Hardware Installation