Nortel Networks 600r manual What is next?

Page 43

Connecting the server to power 43

Note: When the 600r server is plugged into an AC outlet with power, the server automatically powers on. If there is a power outage and the 600r server loses power, the server automatically powers up after power is restored.

Step Action

1Plug the server AC power cord into the server rear panel.

2Plug the other end into an approved wall receptacle or power bar.

—End—

What is next?

Proceed to the Installation and Conﬁguration Task List (NN44200-306) for details.

Nortel CallPilot

600r Server Hardware Installation

NN44200-307 01.03 Standard

5.014 May 2008

Copyright © 2007-2008, Nortel Networks

Image 43

Contents 600r Server Hardware Installation Trademarks Japan Denan statement Information for JapanJapan Vcci statement Page May Publication HistoryMarch Publication History Contents Contents Getting help over the phone from a Nortel Solutions Center Chapter How to get helpGetting help from the Nortel Web site Getting help through a Nortel distributor or reseller Conventions for Warnings Chapter 600r server descriptionThis chapter Server dimensions Server featuresEnvironmental condition Front panel featuresSpecification Environmental speciﬁcationsFront panel Power button NMI button not used Reset button ID buttonLabel Description Rear panel controls and featuresRear panel Label Description PCI riser assembly PCI riser assemblyNetwork connectivity Sample network setup with Communication Server Sample network setup MeridianSample network setup Communication Server Sample network setup with MeridianLAN connectivity Switch connectivitySupported peripheral devices Device Description Remote access connectivitySupported peripheral devices Network requirementsReference documents Introduction Chapter Preparing for installationInstallation overview Installation checklistGlobal CallPilot Support for Anti-Virus Unpacking the 600r server What is next?To unpack the equipment To remove the server cover Inspecting the interior of serverTo replace the server cover Inspecting the interior of server Preparing for installation Installing the server Chapter Installing the server and peripheral devicesTo install the server Connecting peripherals to the serverRear panel connectors To connect the mouse, keyboard, and monitor to the server Rear panel Rear panel connectors Label DescriptionTo connect the external Scsi tape drive To connect the modem to the serverScsi tape drive with terminator Connecting the server to the Elan subnet Media Access Control address Connecting the server to the Nortel server subnet optionalIf the server Then To connect the server to the Nortel server subnet Installing the Nortel software feature dongleDongle plugged in to server To install the software feature dongleInstalling the software feature key Dongle without feature keyContinue with Connecting the server to power Installing the server and peripheral devices Safety information Chapter Connecting the server to powerSafety precautions Locating the power supply modulesBefore you begin Connecting the server to powerAbout the power supply module Rack power and groundingConnecting the server to power Example setup of 600r with peripherals To connect the 600r server to powerWhat is next? Connecting the server to power Chapter EMC emission level protection for the 600r server Ferrite cores secured to an external cable Index Symbols/NumericsIndex Index Index Page 600r Server Hardware Installation