Nortel Networks 600r manual To install the software feature dongle, Dongle plugged in to server

Page 35

Installing the Nortel software feature dongle 35

Figure 9

Dongle plugged in to server

To install the software feature dongle

Step Action

1On the rear panel, ensure that there is nothing plugged in to USB 0, the bottom USB connector.

2If the software feature key is not preinstalled in the dongle, insert the key in to the software feature slot in the dongle.

Nortel CallPilot

600r Server Hardware Installation

NN44200-307 01.03 Standard

5.014 May 2008

Copyright © 2007-2008, Nortel Networks

Image 35

Contents 600r Server Hardware Installation Trademarks Japan Vcci statement Information for JapanJapan Denan statement Page March Publication HistoryMay Publication History Contents Contents Getting help from the Nortel Web site Chapter How to get helpGetting help over the phone from a Nortel Solutions Center Getting help through a Nortel distributor or reseller This chapter Chapter 600r server descriptionConventions for Warnings Server dimensions Server featuresEnvironmental condition Front panel featuresSpecification Environmental speciﬁcationsFront panel Power button NMI button not used Reset button ID buttonRear panel Label Description Rear panel controls and featuresLabel Description Network connectivity PCI riser assemblyPCI riser assembly Sample network setup with Communication Server Sample network setup MeridianSample network setup Communication Server Sample network setup with MeridianLAN connectivity Switch connectivitySupported peripheral devices Device Description Remote access connectivitySupported peripheral devices Network requirementsReference documents Introduction Chapter Preparing for installationInstallation overview Installation checklistGlobal CallPilot Support for Anti-Virus To unpack the equipment What is next?Unpacking the 600r server To replace the server cover Inspecting the interior of serverTo remove the server cover Inspecting the interior of server Preparing for installation Installing the server Chapter Installing the server and peripheral devicesRear panel connectors Connecting peripherals to the serverTo install the server To connect the mouse, keyboard, and monitor to the server Rear panel Rear panel connectors Label DescriptionTo connect the external Scsi tape drive To connect the modem to the serverScsi tape drive with terminator Connecting the server to the Elan subnet If the server Then Connecting the server to the Nortel server subnet optionalMedia Access Control address To connect the server to the Nortel server subnet Installing the Nortel software feature dongleDongle plugged in to server To install the software feature dongleInstalling the software feature key Dongle without feature keyContinue with Connecting the server to power Installing the server and peripheral devices Safety information Chapter Connecting the server to powerSafety precautions Locating the power supply modulesBefore you begin Connecting the server to powerAbout the power supply module Rack power and groundingConnecting the server to power Example setup of 600r with peripherals To connect the 600r server to powerWhat is next? Connecting the server to power Chapter EMC emission level protection for the 600r server Ferrite cores secured to an external cable Index Symbols/NumericsIndex Index Index Page 600r Server Hardware Installation