Nortel Networks 600r manual Dongle without feature key, Installing the software feature key

Page 36

36Chapter 4 Installing the server and peripheral devices

Figure 10

Dongle without feature key

a.To open the dongle to insert the software feature key, gently push back the clip on side of the dongle using a very small screwdriver and pull back on the access door.

b.Insert the software feature key with the data contact facing down and away from the embossed i. (For more information about installing the software feature key, see Figure 11 "Installing the software feature key" (page 36).

Figure 11

Installing the software feature key

3Remove the front protection cover from the dongle.

Nortel CallPilot

600r Server Hardware Installation

NN44200-307 01.03 Standard

5.014 May 2008

Copyright © 2007-2008, Nortel Networks

Image 36

Contents 600r Server Hardware Installation Trademarks Information for Japan Japan Denan statementJapan Vcci statement Page Publication History MayMarch Publication History Contents Contents Chapter How to get help Getting help over the phone from a Nortel Solutions CenterGetting help from the Nortel Web site Getting help through a Nortel distributor or reseller Chapter 600r server description Conventions for WarningsThis chapter Server features Server dimensionsFront panel features SpecificationEnvironmental speciﬁcations Environmental conditionPower button NMI button not used Reset button ID button Front panelRear panel controls and features Label DescriptionRear panel Label Description PCI riser assembly PCI riser assemblyNetwork connectivity Sample network setup Meridian Sample network setup Communication ServerSample network setup with Meridian Sample network setup with Communication ServerSwitch connectivity LAN connectivityRemote access connectivity Supported peripheral devicesNetwork requirements Supported peripheral devices Device DescriptionReference documents Chapter Preparing for installation Installation overviewInstallation checklist IntroductionGlobal CallPilot Support for Anti-Virus What is next? Unpacking the 600r serverTo unpack the equipment Inspecting the interior of server To remove the server coverTo replace the server cover Inspecting the interior of server Preparing for installation Chapter Installing the server and peripheral devices Installing the serverConnecting peripherals to the server To install the serverRear panel connectors Rear panel Rear panel connectors Label Description To connect the mouse, keyboard, and monitor to the serverTo connect the modem to the server To connect the external Scsi tape driveScsi tape drive with terminator Connecting the server to the Elan subnet Connecting the server to the Nortel server subnet optional Media Access Control addressIf the server Then Installing the Nortel software feature dongle To connect the server to the Nortel server subnetTo install the software feature dongle Dongle plugged in to serverDongle without feature key Installing the software feature keyContinue with Connecting the server to power Installing the server and peripheral devices Chapter Connecting the server to power Safety precautionsLocating the power supply modules Safety informationConnecting the server to power About the power supply moduleRack power and grounding Before you beginConnecting the server to power To connect the 600r server to power Example setup of 600r with peripheralsWhat is next? Connecting the server to power Chapter EMC emission level protection for the 600r server Ferrite cores secured to an external cable Symbols/Numerics IndexIndex Index Index Page 600r Server Hardware Installation