Nortel Networks 600r manual Chapter Installing the server and peripheral devices

Page 27

27

Chapter 4

Installing the server and peripheral devices

In this chapter

"Installing the server" (page 27)

"Connecting peripherals to the server" (page 28)

"Connecting the server to the ELAN subnet" (page 32)

"Connecting the server to the Nortel server subnet (optional)" (page 33)

"Installing the Nortel software feature dongle" (page 34)

Installing the server

Before you install the 600r server, ensure that the chosen location meets the requirements identiﬁed in the Site inspection checklist provided in the Installation and Conﬁguration Task List (NN44200-306).

Note: The 600r server is supplied with industry standard 48.3 cm (19 in.) rack rails that can accommodate racks with a maximum depth of 61 cm (24 in.) between the mounting posts. Check the rack you are using and ensure that the Nortel supplied server rack rails are suitable for your speciﬁc installation requirements. For depths greater than 61 cm (24 in.), Nortel recommends that you purchase a third-party rack shelf that can safely hold up to 23 kg (50 lb.)

Nortel CallPilot

600r Server Hardware Installation

NN44200-307 01.03 Standard

5.014 May 2008

Copyright © 2007-2008, Nortel Networks

Image 27

Contents 600r Server Hardware Installation Trademarks Information for Japan Japan Denan statementJapan Vcci statement Page Publication History MayMarch Publication History Contents Contents Chapter How to get help Getting help over the phone from a Nortel Solutions CenterGetting help from the Nortel Web site Getting help through a Nortel distributor or reseller Chapter 600r server description Conventions for WarningsThis chapter Server dimensions Server featuresEnvironmental condition Front panel featuresSpecification Environmental speciﬁcationsFront panel Power button NMI button not used Reset button ID buttonRear panel controls and features Label DescriptionRear panel Label Description PCI riser assembly PCI riser assemblyNetwork connectivity Sample network setup with Communication Server Sample network setup MeridianSample network setup Communication Server Sample network setup with MeridianLAN connectivity Switch connectivitySupported peripheral devices Device Description Remote access connectivitySupported peripheral devices Network requirementsReference documents Introduction Chapter Preparing for installationInstallation overview Installation checklistGlobal CallPilot Support for Anti-Virus What is next? Unpacking the 600r serverTo unpack the equipment Inspecting the interior of server To remove the server coverTo replace the server cover Inspecting the interior of server Preparing for installation Installing the server Chapter Installing the server and peripheral devicesConnecting peripherals to the server To install the serverRear panel connectors To connect the mouse, keyboard, and monitor to the server Rear panel Rear panel connectors Label DescriptionTo connect the external Scsi tape drive To connect the modem to the serverScsi tape drive with terminator Connecting the server to the Elan subnet Connecting the server to the Nortel server subnet optional Media Access Control addressIf the server Then To connect the server to the Nortel server subnet Installing the Nortel software feature dongleDongle plugged in to server To install the software feature dongleInstalling the software feature key Dongle without feature keyContinue with Connecting the server to power Installing the server and peripheral devices Safety information Chapter Connecting the server to powerSafety precautions Locating the power supply modulesBefore you begin Connecting the server to powerAbout the power supply module Rack power and groundingConnecting the server to power Example setup of 600r with peripherals To connect the 600r server to powerWhat is next? Connecting the server to power Chapter EMC emission level protection for the 600r server Ferrite cores secured to an external cable Index Symbols/NumericsIndex Index Index Page 600r Server Hardware Installation