Nortel Networks 600r Chapter Preparing for installation, Installation overview, Introduction

Page 21

21

Chapter 3

Preparing for installation

In this Chapter

"Installation overview" (page 21)

"Unpacking the 600r server" (page 23)

"Inspecting the interior of server" (page 24)

Installation overview

Introduction

This section provides an overview of the steps required to install the 600r server and peripheral devices. For detailed instructions, see Chapter 4 "Installing the server and peripheral devices" (page 27)

When you are ﬁnished, continue with the switch and server setup as described in the documentation for your switch:

•Communication Server 1000 and CallPilot Server Conﬁguration (NN44200-312)

•Meridian 1 and CallPilot Server Conﬁguration (NN44200-302)

Installation checklist

Step	Description	Check
1	Review the "Installing the CallPilot server" section in the	__
	Installation and Configuration Task List (NN44200-306),
	and complete stage 1 of the Installation checklist.

Nortel CallPilot

600r Server Hardware Installation

NN44200-307 01.03 Standard

5.014 May 2008

Copyright © 2007-2008, Nortel Networks

Image 21

Contents 600r Server Hardware Installation Trademarks Information for Japan Japan Denan statementJapan Vcci statement Page Publication History MayMarch Publication History Contents Contents Chapter How to get help Getting help over the phone from a Nortel Solutions CenterGetting help from the Nortel Web site Getting help through a Nortel distributor or reseller Chapter 600r server description Conventions for WarningsThis chapter Server dimensions Server featuresSpecification Front panel featuresEnvironmental speciﬁcations Environmental conditionFront panel Power button NMI button not used Reset button ID buttonRear panel controls and features Label DescriptionRear panel Label Description PCI riser assembly PCI riser assemblyNetwork connectivity Sample network setup Communication Server Sample network setup MeridianSample network setup with Meridian Sample network setup with Communication ServerLAN connectivity Switch connectivitySupported peripheral devices Remote access connectivityNetwork requirements Supported peripheral devices Device DescriptionReference documents Installation overview Chapter Preparing for installationInstallation checklist IntroductionGlobal CallPilot Support for Anti-Virus What is next? Unpacking the 600r serverTo unpack the equipment Inspecting the interior of server To remove the server coverTo replace the server cover Inspecting the interior of server Preparing for installation Installing the server Chapter Installing the server and peripheral devicesConnecting peripherals to the server To install the serverRear panel connectors To connect the mouse, keyboard, and monitor to the server Rear panel Rear panel connectors Label DescriptionTo connect the external Scsi tape drive To connect the modem to the serverScsi tape drive with terminator Connecting the server to the Elan subnet Connecting the server to the Nortel server subnet optional Media Access Control addressIf the server Then To connect the server to the Nortel server subnet Installing the Nortel software feature dongleDongle plugged in to server To install the software feature dongleInstalling the software feature key Dongle without feature keyContinue with Connecting the server to power Installing the server and peripheral devices Safety precautions Chapter Connecting the server to powerLocating the power supply modules Safety informationAbout the power supply module Connecting the server to powerRack power and grounding Before you beginConnecting the server to power Example setup of 600r with peripherals To connect the 600r server to powerWhat is next? Connecting the server to power Chapter EMC emission level protection for the 600r server Ferrite cores secured to an external cable Index Symbols/NumericsIndex Index Index Page 600r Server Hardware Installation