Nortel Networks 600r Sample network setup Meridian, Sample network setup Communication Server

Page 17

Network connectivity 17

Sample network setup: Meridian 1

The Meridian 1 switch can be one of the following:

•Option 11C or Option 11C Mini using ﬁber connections

•Option 51C

•Option 61C

•Options 81 and 81C

The following diagram shows a CallPilot 600r server network setup with a Meridian 1 switch.

Figure 5

Sample network setup with Meridian 1

Sample network setup: Communication Server 1000

The following diagram shows a CallPilot 600r server network setup with a CS 1000 system:

Figure 6

Sample network setup with Communication Server 1000

Nortel CallPilot

600r Server Hardware Installation

NN44200-307 01.03 Standard

5.014 May 2008

Copyright © 2007-2008, Nortel Networks

Image 17

Contents 600r Server Hardware Installation Trademarks Japan Vcci statement Information for JapanJapan Denan statement Page March Publication HistoryMay Publication History Contents Contents Getting help from the Nortel Web site Chapter How to get helpGetting help over the phone from a Nortel Solutions Center Getting help through a Nortel distributor or reseller This chapter Chapter 600r server descriptionConventions for Warnings Server dimensions Server featuresSpecification Front panel featuresEnvironmental speciﬁcations Environmental condition Front panel Power button NMI button not used Reset button ID buttonRear panel Label Description Rear panel controls and featuresLabel Description Network connectivity PCI riser assemblyPCI riser assembly Sample network setup Communication Server Sample network setup MeridianSample network setup with Meridian Sample network setup with Communication ServerLAN connectivity Switch connectivitySupported peripheral devices Remote access connectivityNetwork requirements Supported peripheral devices Device DescriptionReference documents Installation overview Chapter Preparing for installationInstallation checklist IntroductionGlobal CallPilot Support for Anti-Virus To unpack the equipment What is next?Unpacking the 600r server To replace the server cover Inspecting the interior of serverTo remove the server cover Inspecting the interior of server Preparing for installation Installing the server Chapter Installing the server and peripheral devicesRear panel connectors Connecting peripherals to the serverTo install the server To connect the mouse, keyboard, and monitor to the server Rear panel Rear panel connectors Label DescriptionTo connect the external Scsi tape drive To connect the modem to the serverScsi tape drive with terminator Connecting the server to the Elan subnet If the server Then Connecting the server to the Nortel server subnet optionalMedia Access Control address To connect the server to the Nortel server subnet Installing the Nortel software feature dongleDongle plugged in to server To install the software feature dongleInstalling the software feature key Dongle without feature keyContinue with Connecting the server to power Installing the server and peripheral devices Safety precautions Chapter Connecting the server to powerLocating the power supply modules Safety informationAbout the power supply module Connecting the server to powerRack power and grounding Before you beginConnecting the server to power Example setup of 600r with peripherals To connect the 600r server to powerWhat is next? Connecting the server to power Chapter EMC emission level protection for the 600r server Ferrite cores secured to an external cable Index Symbols/NumericsIndex Index Index Page 600r Server Hardware Installation