Keyboard Installation and Operation
Running Patterns
A pattern is a series of pan, tilt, zoom, and focus commands defined for a dome camera. A pattern is programmed in real time, which means that the dome remembers each pattern segment in the actual time it takes the operator to execute a command.
To run a pattern:
1.Call the camera that the pattern will run on.
2.Enter the pattern number using the numeric keys. The number entered will appear on the right hand side of the top line of the LCD display.
3.Hold down the SHIFT (
) key and press the PATTERN (
) key.
Dome Camera DirectSet
The DirectSet feature allows certain dome camera functions to be accessed quickly from the keyboard. Please note that this feature is not available on some dome cameras or controller/matrix systems.
To access the DirectSet menu:
1.Call a monitor.
2.Call a suitable dome camera to command of the keyboard.
3.Press the DIRECTSET (
) key.
The dome camera's DirectSet menu will be displayed on the currently selected monitor. Note that the menu options shown depend on the dome camera in use.
0TOGGLE DIRECTSET MENU
1DOME CONFIG MENU
2AUTO IRIS/AUTO FOCUS
3FLIP
4PEEL PATTERN
10NIGHT MODE
11DAY MODE
12AUTO DAY/NIGHT MODE
13WDR ON
14WDR OFF
255 RESET DOME
To call a DirectSet function:
1.Enter the number of the function using the numeric keys.
2.Press the DIRECTSET (
) key.
For example if a dome flip function was required, enter 3 and press the DIRECTSET key.
If the number for the DirectSet feature is already known to the operator, it can be entered on the numeric keypad and the DirectSet key pressed directly. It is not necessary to call the DirectSet feature menu to the monitor.
21