GBC F-36 34/5, 346!575, One-Pass Mounting and Laminating

Page 28

Operation	F-36 PRO Laminator Operation Manual

34*/5

One-Pass Mounting and Laminating

MATERIALS

Upper Media	3 mil gloss	Image Media	Bond Paper

Lower Media	N/A	Mounting Substrate	Falcon Board

	LAMINATOR SETTINGS

Top Heater Status	ON @ 240 ºF (115 ºC)	Drive Mode	Manual (Footswitch)

Bottom Heater Status	OFF	Pull Roll Position	UP

Speed	1-2 ft/min	Output Cooling	OFF

Drive Direction	FWD	Main Roll Setting	DOWN - 1/4 turn

34*6!575

Leader

Board

Printed

Image

FALCON

Board

Notes

___________________________________________________________________________________________

___________________________________________________________________________________________

___________________________________________________________________________________________

3-10	© GBC Pro-Tech 1999 January

Image 28

Contents GBC Pro-Tech 1999 January Preinstallation Checklist Unpacking Setup Startup Machine Shutdown Safety Using the Emergency Stop ButtonsGBC Pro-Tech 1999 January & $* * Locations of Safety Labels Decal Meaning ! Position the jumpers as shown in -6 for Service choice # + Installation Laminator Space RequirementsTools required +$If the laminator is in a cardboard box Foot Bolt Shipping Pad If the laminator is in a crate Removing the CrateSetup Procedure Power Cord Connection Startup Checklist Operation -# $# $ $# $ # Then mounted $Insert a starter board into the nip and lower # #-34*/5 Identification Diagram34*6!575 34*6!575 34*/5One-Pass Mounting and Laminating 34*6!575 34*/5One-Pass Mounting 34*6!5755 34*/55Two Pass Mount and Cold/Pressure Overlaminate, First Pass 34*6!5758 34*/58Two Pass Mount and Cold/Pressure Overlaminate, Second Pass 34*6!575%5 34*/5%5Two Pass Mount and Hot Overlaminate, First Pass 34*6!575%8 34*/5%8Two Pass Mount and Hot Overlaminate, Second Pass 34*6!575 34*/5Encapsulation #$ Maintenance and Troubleshooting Firmly hold the thermocouple where the guitarUpper Main To clean the laminator rolls To clean beads of adhesive, dust and dirt from the rollsTo clean the cabinet and covers 9$# 4To adjust the chain tension # $ $ # #$7 Unauthorized customer alterations will void this Warranty This warranty specifically does not cover. & Warranty Part Description Recommended QuantitySpecifications Nip 1-1, 1-2, 2-6, 2-8, 3-1, 4-1, 4-4, 4-5Index