GBC F-36 manual , Preinstallation Checklist Unpacking Setup Startup

Page 3

F-36 PRO Laminator Operation Manual

Caution/Warning Label Locations

1-4

!

Preinstallation Checklist	2-1
Unpacking	2-3
Setup	2-6
Startup	2-8

Safety	3-1
Operator Controls	3-2
Front Control Panel	3-2
Footswitch Operation	3-3
Setup	3-3
Laminator Roll Pressure	3-3
Loading the Film	3-3
Recommended Materials	3-4
Films (Excluding Vinyl Transfer and Overlamination)	3-4
Positioning the Film	3-4
Heating	3-4
Cooling	3-5
Paper Tips	3-5
Process Control Charts	3-5
Mounting and Laminating (One Pass)	3-5
Setup and Procedure	3-5
Mounting Only	3-6
Setup and Procedure	3-6
Two-Pass Mount and Laminate (Cold Overlaminate)	3-6
Setup and Procedure, Pass 1	3-6
Setup and Procedure, Pass 2	3-7
Two-Pass Mount and Laminate (Hot Overlaminate)	3-7
Setup and Procedure, Pass 1	3-7
Setup and Procedure, Pass 2	3-7
Encapsulation	3-8
Setup and Procedure	3-8

© GBC Pro-Tech 1999 January

iii

Image 3

Contents GBC Pro-Tech 1999 January Preinstallation Checklist Unpacking Setup StartupMachine Shutdown Using the Emergency Stop Buttons SafetyGBC Pro-Tech 1999 January & $* * Locations of Safety Labels Decal Meaning Position the jumpers as shown in -6 for Service choice ! # + Laminator Space Requirements Installation +$ Tools requiredIf the laminator is in a cardboard box Foot Bolt Shipping Pad Removing the Crate If the laminator is in a crate Setup ProcedurePower Cord Connection Startup Checklist Operation$# -# $# $$ # $ Then mountedInsert a starter board into the nip and lower # #- Identification Diagram 34*/534*6!575 34*/5 34*6!575One-Pass Mounting and Laminating 34*/5 34*6!575One-Pass Mounting 34*/55 34*6!5755Two Pass Mount and Cold/Pressure Overlaminate, First Pass 34*/58 34*6!5758Two Pass Mount and Cold/Pressure Overlaminate, Second Pass 34*/5%5 34*6!575%5Two Pass Mount and Hot Overlaminate, First Pass 34*/5%8 34*6!575%8Two Pass Mount and Hot Overlaminate, Second Pass 34*/5 34*6!575Encapsulation #$ Firmly hold the thermocouple where the guitar Maintenance and TroubleshootingUpper Main To clean beads of adhesive, dust and dirt from the rolls To clean the laminator rolls9$# 4 To clean the cabinet and covers# $ To adjust the chain tension$ # #$7 This warranty specifically does not cover Unauthorized customer alterations will void this Warranty. & Warranty Quantity Part Description RecommendedSpecifications Nip 1-1, 1-2, 2-6, 2-8, 3-1, 4-1, 4-4, 4-5 Index