GBC F-36 manual 34/5%5, 346!575%5

Page 32

Operation	F-36 PRO Laminator Operation Manual

34*/5%5

Two Pass Mount and Hot Overlaminate, First Pass

MATERIALS

Upper Media	3 mil Gloss	Image Media	Bond Paper

Lower Media	Pro-Mount	Mounting Substrate	N/A

	LAMINATOR SETTINGS

Top Heater Status	ON @ 230 ºF (110 ºC)	Drive Mode	Manual or Auto

Bottom Heater Status	OFF	Pull Roll Position	DOWN

Speed	3-4 ft/min	Output Cooling	OFF

Drive Direction	FWD	Main Roll Setting	DOWN - 1/2 turn

34*6!575%5

Notes

___________________________________________________________________________________________

___________________________________________________________________________________________

___________________________________________________________________________________________

3-14	© GBC Pro-Tech 1999 January

Image 32

Contents GBC Pro-Tech 1999 January Preinstallation Checklist Unpacking Setup Startup Machine Shutdown Safety Using the Emergency Stop ButtonsGBC Pro-Tech 1999 January & $* * Locations of Safety Labels Decal Meaning # + Position the jumpers as shown in -6 for Service choice ! Installation Laminator Space RequirementsIf the laminator is in a cardboard box +$Tools required Foot Bolt Shipping Pad If the laminator is in a crate Removing the CrateSetup Procedure Power Cord Connection Startup Checklist Operation -# $# $ $# # $ Then mounted $Insert a starter board into the nip and lower # #-34*6!575 Identification Diagram34*/5 One-Pass Mounting and Laminating 34*/534*6!575 One-Pass Mounting 34*/534*6!575 Two Pass Mount and Cold/Pressure Overlaminate, First Pass 34*/5534*6!5755 Two Pass Mount and Cold/Pressure Overlaminate, Second Pass 34*/5834*6!5758 Two Pass Mount and Hot Overlaminate, First Pass 34*/5%534*6!575%5 Two Pass Mount and Hot Overlaminate, Second Pass 34*/5%834*6!575%8 Encapsulation 34*/534*6!575 #$ Maintenance and Troubleshooting Firmly hold the thermocouple where the guitarUpper Main To clean the laminator rolls To clean beads of adhesive, dust and dirt from the rollsTo clean the cabinet and covers 9$# 4To adjust the chain tension # $ $ # #$7 . & This warranty specifically does not coverUnauthorized customer alterations will void this Warranty Warranty Part Description Recommended QuantitySpecifications Nip 1-1, 1-2, 2-6, 2-8, 3-1, 4-1, 4-4, 4-5Index