GBC F-36 manual 34/58, 346!5758

Page 31

F-36 PRO Laminator Operation Manual	Operation

34*/5"8

Two Pass Mount and Cold/Pressure Overlaminate, Second Pass

MATERIALS

Upper Media	N/A		Image Media	N/A

Lower Media	N/A		Mounting Substrate	Foam Core

		LAMINATOR SETTINGS

Top Heater Status	OFF		Drive Mode	Manual (Footswitch)

Bottom Heater Status	OFF		Pull Roll Position	UP

Speed	2-6 ft/min		Output Cooling	OFF

Drive Direction	FWD		Main Roll Setting	DOWN - 1/4 turn

34*6!575"8

Hold Encapsulated

Image

Image

Face

Release

Liner

Notes

__________________________________________________________________________________________

__________________________________________________________________________________________

__________________________________________________________________________________________

© GBC Pro-Tech 1999 January

3-13

Image 31

Contents GBC Pro-Tech 1999 January Preinstallation Checklist Unpacking Setup StartupMachine Shutdown Using the Emergency Stop Buttons SafetyGBC Pro-Tech 1999 January & $* * Locations of Safety Labels Decal Meaning ! Position the jumpers as shown in -6 for Service choice # + Laminator Space Requirements InstallationTools required +$If the laminator is in a cardboard box Foot Bolt Shipping Pad Removing the Crate If the laminator is in a crate Setup ProcedurePower Cord Connection Startup Checklist Operation$# -# $# $ $ # $ Then mountedInsert a starter board into the nip and lower # #- 34*/5 Identification Diagram34*6!575 34*6!575 34*/5One-Pass Mounting and Laminating 34*6!575 34*/5One-Pass Mounting 34*6!5755 34*/55Two Pass Mount and Cold/Pressure Overlaminate, First Pass 34*6!5758 34*/58Two Pass Mount and Cold/Pressure Overlaminate, Second Pass 34*6!575%5 34*/5%5Two Pass Mount and Hot Overlaminate, First Pass 34*6!575%8 34*/5%8Two Pass Mount and Hot Overlaminate, Second Pass 34*6!575 34*/5Encapsulation #$ Firmly hold the thermocouple where the guitar Maintenance and TroubleshootingUpper Main To clean beads of adhesive, dust and dirt from the rolls To clean the laminator rolls9$# 4 To clean the cabinet and covers# $ To adjust the chain tension$ # #$7 Unauthorized customer alterations will void this Warranty This warranty specifically does not cover. & Warranty Quantity Part Description RecommendedSpecifications Nip 1-1, 1-2, 2-6, 2-8, 3-1, 4-1, 4-4, 4-5 Index