GBC F-36 manual Machine Shutdown

Page 4

	F-36 PRO Laminator Operation Manual

Machine Shutdown	.......................................................................................................... 3-8
Procedure	3-8

" #$ "

Thermocouple Positioning and Cleaning	4-1
Adjusting the Nip	4-5
Chain Tensioning	4-6
Lubrication	4-7
Contacting Technical Support	4-7
Output Troubleshooting Guide	4-8

%& %

Limited Warranty	5-1
Exclusions to the Warranty	5-1

'! ('

iv	© GBC Pro-Tech 1999 January

Image 4

Contents GBC Pro-Tech 1999 January Preinstallation Checklist Unpacking Setup Startup Machine Shutdown Safety Using the Emergency Stop ButtonsGBC Pro-Tech 1999 January & $* * Locations of Safety Labels Decal Meaning ! Position the jumpers as shown in -6 for Service choice # + Installation Laminator Space RequirementsTools required +$If the laminator is in a cardboard box Foot Bolt Shipping Pad If the laminator is in a crate Removing the CrateSetup Procedure Power Cord Connection Startup Checklist Operation -# $# $ $# $ # Then mounted $Insert a starter board into the nip and lower # #-34*/5 Identification Diagram34*6!575 34*6!575 34*/5One-Pass Mounting and Laminating 34*6!575 34*/5One-Pass Mounting 34*6!5755 34*/55Two Pass Mount and Cold/Pressure Overlaminate, First Pass 34*6!5758 34*/58Two Pass Mount and Cold/Pressure Overlaminate, Second Pass 34*6!575%5 34*/5%5Two Pass Mount and Hot Overlaminate, First Pass 34*6!575%8 34*/5%8Two Pass Mount and Hot Overlaminate, Second Pass 34*6!575 34*/5Encapsulation #$ Maintenance and Troubleshooting Firmly hold the thermocouple where the guitarUpper Main To clean the laminator rolls To clean beads of adhesive, dust and dirt from the rollsTo clean the cabinet and covers 9$# 4To adjust the chain tension # $ $ # #$7 Unauthorized customer alterations will void this Warranty This warranty specifically does not cover. & Warranty Part Description Recommended QuantitySpecifications Nip 1-1, 1-2, 2-6, 2-8, 3-1, 4-1, 4-4, 4-5Index