GBC F-36 manual 34/5, 346!575, One-Pass Mounting

Page 29

F-36 PRO Laminator Operation ManualOperation

34*/5

One-Pass Mounting

MATERIALS

Upper Media	N/A	Image Media	Bond Paper

Lower Media	N/A	Mounting Substrate	Falcon Board

	LAMINATOR SETTINGS

Top Heater Status	ON @ 240 ºF (115 ºC)	Drive Mode	Manual (Footswitch)

Bottom Heater Status	OFF	Pull Roll Position	UP

Speed	2-3 ft/min	Output Cooling	OFF

Drive Direction	FWD	Main Roll Setting	DOWN - 1/4 turn

34*6!575

Printed

Image

FALCON

Board

Notes

__________________________________________________________________________________________

__________________________________________________________________________________________

__________________________________________________________________________________________

© GBC Pro-Tech 1999 January

3-11

Image 29

Contents GBC Pro-Tech 1999 January Preinstallation Checklist Unpacking Setup StartupMachine Shutdown Using the Emergency Stop Buttons SafetyGBC Pro-Tech 1999 January & $* * Locations of Safety Labels Decal Meaning # + Position the jumpers as shown in -6 for Service choice ! Laminator Space Requirements InstallationIf the laminator is in a cardboard box +$Tools required Foot Bolt Shipping Pad Removing the Crate If the laminator is in a crate Setup ProcedurePower Cord Connection Startup Checklist Operation$# -# $# $ # $ $ Then mountedInsert a starter board into the nip and lower # #- 34*6!575 Identification Diagram34*/5 One-Pass Mounting and Laminating 34*/534*6!575 One-Pass Mounting 34*/534*6!575 Two Pass Mount and Cold/Pressure Overlaminate, First Pass 34*/5534*6!5755 Two Pass Mount and Cold/Pressure Overlaminate, Second Pass 34*/5834*6!5758 Two Pass Mount and Hot Overlaminate, First Pass 34*/5%534*6!575%5 Two Pass Mount and Hot Overlaminate, Second Pass 34*/5%834*6!575%8 Encapsulation 34*/534*6!575 #$ Firmly hold the thermocouple where the guitar Maintenance and TroubleshootingUpper Main To clean beads of adhesive, dust and dirt from the rolls To clean the laminator rolls9$# 4 To clean the cabinet and covers# $ To adjust the chain tension$ # #$7 . & This warranty specifically does not coverUnauthorized customer alterations will void this Warranty Warranty Quantity Part Description RecommendedSpecifications Nip 1-1, 1-2, 2-6, 2-8, 3-1, 4-1, 4-4, 4-5 Index