Toshiba EO1-32004BE, H-9000N-US owner manual Print Format, By pressing Key

9.PROGRAMMING PROCEDURES

9.11 PRINT FORMAT

9.11PRINT FORMAT

Menu Page: 2

Item No.: 0

The The H-9000 can memorize 5 different print formats. After print formats are set, you can call them by pressing the print format number.

<MENU>

Page 2

0

Select the print format # which allocates the label format #

by the NEXT PLU key or key.

Enter the label format #.

(Refer to table 2)

CHANGE

PLU

Issue method		On-demand
Batch	Select “SENSIBILITY ADJUST”				SET
	by pressing the		◇ key.
					NEXT
	When Batch Printing with backing paper is
	selected, the sensitivity of the label sensor will
	be set by pressing the SET NEXT			key before
	issuing label.

	j
		Is print	Correct
	TEST	position
FEED
		correct?

Incorrect

Select the Item for adjustment.

1gradation =0.154 mm (1 dot)

1 gradation

=0.462 mm (3 dots)

1 gradation

=0.462 mm (3 dots)

Only when using the bar code change label with pre-feed area. (This adjustment cannot be made on the Variable Length Label.)

◇

Enter the correct label feed value.

(Range: 0～199)

Enter the correct value for commodity name position. (Range: 0～9)

Enter the correct value for address position. (Range: 0～15)

Enter the correct value for pre-feed area.

(Range: 0～65)

ENTER

ENTER

ENTER

ENTER

j

j

j

j

CHANGE

PLU

<MENU>	PROG.
Page 2

Main
	ESC.
<MENU>

NOTES:

1.When a commodity name position is adjusted, an address position will move automatically.

2.When entering the other label format #, fine adjust values are initialized.

3.Selecting label format numbers other than those provided in Table 2 results in an error.

4.When selecting a variable length label format, rectangles are printed instead of print items when test printing.

5. Pressing the ◇ key allows you to select a print format number from 1 to 5.

6.Be sure to press the SET NEXT key when a label format for batch printing with backing paper is selected.

9- 18