Toshiba H-9000N-US, EO1-32004BE owner manual TARE/SAVE Function Procedures, Platter

12. OPERATING PROCEDURES

12.6 TARE/SAVE FUNCTION PROCEDURES

12.6TARE/SAVE FUNCTION PROCEDURES

NOTE: This operation is available only when the optional scale unit is connected.

Menu:	REG., M.DOWN, or REWRAP
Mode:	WEIGH or FIX (Tare % function is available in WEIGH mode only.)

There aretwo kinds of tare subtraction procedures, one is “Direct tare”, the other is “Preset tare “.
The	SAVE	key is used to save the tare, unit price, and PLU data after taking a commodity from the
platter.						Tare %
		0.200 lb	2	0	0
	Place a container on				1	0	0
	the platter.
	(Ex. 0.200 lb)			T	Press:
		T				%
	Press:
					Place a container
					on the platter

Enter the PLU #. 1 0 0

Tare %

Press:

PLU

%

The PLU data and tare are	SAVE
saved.

Place a commodity on the platter.

(Ex. 1.000 lb)

1 0 0

%

Remove the Commodity together with the container.

	Press:	C
CA type			US type

MANUAL:

:AUTO

PLU Press: 0 Press:

* The label is issued.

T Press:

Press: C

Remove the commodity together with the container.

PLU

Press:

NOTES: 1. Tare subtraction is available up to 2.000 lb. When tare subtraction is in operation, however, the scalable range for net weight becomes less by the amount of the tare. (Net weight-Grossweight-Tare)

2.Preset tare must be a multiple of 0.005 lb.

3.The tare % function is available when the Initial Setting #28-4 is set to 1. The speed key #70 will function as the % key (Refer to page 5-3). Set a tare % within the range from 0.0 to 99.9.

4.When a commodity is placed on the platter and the calculated tare exceeds the maximum, a “TARE WEIGH OVER” error will occur.

12-11