Toshiba B-852-TS12-QQ owner manual ∙ Descriptions of the Maintenance Counter

APPENDIX 4 SYSTEM MODE

EO1-33029

A4.7 Additional Information

A4.7.2 Maintenance Counter/Parameter Check Print Sample and Descriptions (Cont.)

∙Descriptions of the Maintenance Counter

No.	Item	Count Condition	Range
(1)	Total media distance covered	Counted when the feed motor is driven to	0.0 to 2000.0 km
		feed, print and issue the media. (Counted
(2)	Media distance covered	also during ribbon saving operation and	0.0 to 181.9 km
		back feed.) See NOTE 6 and 7.
(3)	Print distance	Counted while printing. (Feeding and back	0.0 to 200.0 km
		feed are not counted.) See NOTE 2.
(4)	Cut count	Counts every cut. [See NOTE 3.]	0 to 1000000 times
		Counts when the ribbon motor is driven to
(5)	Ribbon motor driving time	feed, print and issue the media. (The	0 to 2000 hours
		driving time is not counted during ribbon
		saving operation, but is during back feed.)
(6)	RS-232C hardware error	Counted when a parity, overrun or framing	0 to 255 times
	count	error occurs. See NOTE 5.
(7)	System error count	Counted when any error occurs.	0 to 15 times
(8)	Momentary power failure	Counts the number of times the power	0 to 15 times
	count	restores while the CPU is busy after reset.

NOTES:

1.Item from (2) through (10) are initialized to “0” after RAM clear.

2.If the Print distance is 5.5m or less, it is rounded down and no data is added to the memory at power off.

3.If the count is 31 counts or less, it is rounded down and no data is added to the memory at power off.

4.If the driving time is 27 sec. or less, it is rounded down and no data is added to the memory at power off.

5.When a sent command results in an error, the same number as the data capacity of the command is counted by byte.

6.If the media distance covered is 69.4 cm or less, it is rounded down and no data is added to the memory at power off.

7.When the media distance covered reached to the maximum, the maintenance counter should be cleared. Otherwise, the total media distance covered will not be updated. For the maintenance counter clear, please contact your nearest TOSHIBA TEC service representative.

∙Descriptions of the Parameters

No.	Item	Contents
(9)	Feed length fine adjustment (PC), (KEY)	-50.0 mm to +50.0 mm
(10)	Cut position fine adjustment (PC), (KEY)	-50.0 mm to +50.0 mm
(11)	Back feed length fine adjustment (PC), (KEY)	-9.9 mm to +9.9 mm
(12)	Print tone fine adjustment (Thermal transfer), (PC),	-10 step to +10 step
	(KEY)
(13)	Print tone fine adjustment (Thermal direct), (PC),	-10 step to +10 step
	(KEY)
(14)	Ribbon rewind motor driving voltage fine adjustment	-15 step to +0 step
	(PC), (KEY)
(15)	Ribbon feed motor driving voltage fine adjustment	-15 step to +10 step
	(PC), (KEY)
(16)	X axis fine adjustment	-99.5 mm to +99.5 mm
(17)	Threshold manual fine adjustment for the black mark	0.0V to 4.0V
	sensor
(18)	Threshold manual fine adjustment for the feed gap	0.0V to 4.0V
	sensor

A4-28