Toshiba B-852-TS12-QQ owner manual Characters, Barcode, Non-Printing, Factory Test

APPENDIX 4 SYSTEM MODE

EO1-33029

A4.5 Test Print

A4.5 Test Print (Cont.)

Print Sample of Characters

Characters

&+$5$&7(56￿

While selecting the Characters, press the [PAUSE] key to start printing the characters. After printing is completed, the display returns to “<4>TEST PRINT”.

Pressing the [PAUSE] key causes the display to show “CHARACTERS” again. Then, press the [FEED] key.

Barcode

Print Sample of Barcodes %$5&2'(￿

NOTE:

The Non-Printing function simply looks like a media feed.

Print Sample of Non-print

NOTES:

∙Factory test print conditions: One paper feed, Slant lines (3 dots), Bar codes, Characters, Item count: 5 pcs. each, Print speed: 4”/sec., Sensor type: Black mark (Lower side) or Feed gap sensor

∙When the feed gap sensor is selected, a gap length is 3 mm.

Print method: Thermal

transfer, Issue mode: Batch printing (without cut), Label length: 76 mm, Print tone fine adjustment.

While selecting the Barcode, press the [PAUSE] key to start printing the bar codes. After printing is completed, the display returns to “<4>TEST PRINT”.

Pressing the [PAUSE] key causes the display to shown “BARCODE” again. Then, press the [FEED] key.

Non-Printing

121￿35,17,1*￿

While selecting the Non-printing, press the [PAUSE] key to start issuing a blank page of media. After printing is completed, the display returns to “<4>TEST PRINT”.

Pressing the [PAUSE] key causes the display to shown “NON- PRINTING” again. Then, press the [FEED] key.

Factory Test

)$&725<￿7(67￿

While selecting the Factory test, press the [PAUSE] key to start printing the factory test pattern. After printing is completed, the display returns to “<4>TEST PRINT”.

Pressing the [PAUSE] key causes the display to indicate “FACTORY TEST” again. Then, press the [FEED] key.

mark (Lower side) or Feed

A4-18