Toshiba B-852-TS12-QQ owner manual Appendix 2 Messages and Leds, Symbols in the message

APPENDIX 2 MESSAGES AND LEDS

EO1-33029

APPENDIX 2 MESSAGES AND LEDS

APPENDIX 2 MESSAGES AND LEDS

Appendix 4 describes the LCD messages displayed on the operation panel.

Symbols in the message

1:•: The LED is illuminated. ~: The LED is flashing. z: The LED is unlit.

2:****: the number of unprinted media. Up to 9999 (in pieces)

3:%%%%%%%: ATA Card’s remaining memory 0 to 9999999 (in K bytes)

4:###: Flash memory card remaining memory for PC save area: 0 to 895 (in K bytes)

5:&&&&: Remaining flash memory capacity for storing writable characters 0 to 3147 (in K bytes)

		LED Indication		Restoration	Acceptance of
				by RESTART	Status Request
No.	LCD Message		Printer Status
				key Yes/No	Reset Command
		POWER ONLINE ERROR			Yes/No

1	ON LINE		•	•	z	In online mode	-----	Yes
	ON LINE		•	~	z	In online mode (The printer in	-----	Yes
						communication)
2	HEAD OPEN		•	z	z	The print head block is opened in online	-----	Yes
						mode.
3	PAUSE ****		•	z	z	The printer is paused.	Yes	Yes
4						A parity, overrun, or framing error has	Yes	Yes
	COMMS ERROR		•	z	•	occurred during communication through
						the RS-232C.
5	PAPER JAM	****	•	z	•	The media is jammed during paper feed.	Yes	Yes
6	CUTTER ERROR****		•	z	•	A problem has occurred with the cutter	Yes	Yes
						module.
7						The media has run out, or the media is	Yes	Yes
	NO PAPER	****	•	z	•	not loaded on the supply holder
						properly.
						The ribbon has run out, or has been torn.	Yes	Yes
8	RIBBON ERROR****		•	z	•	A problem has occurred with the sensor
						that determines the torque for the ribbon
						motor.
9	HEAD OPEN	****	•	z	•	Feed or printing was attempted with the	Yes	Yes
						print head block open.
10	EXCESS HEAD TEMP		•	z	•	The print head is overheated.	No	Yes
	SAVING%%%%%%%					In writable character or PC command	-----	Yes
11	or		•	•	z	save mode
	SAVING ###&&&&
12	FLASH WRITE ERR.		•	z	•	An error has occurred while writing to	No	Yes
						flash memory or ATA card.
13						An erase error has occurred in	No	Yes
	FORMAT ERROR		•	z	•	formatting the flash memory or ATA
						card.
14	FLASH CRD FULL		•	z	•	Data cannot be stored because the flash	No	Yes
						memory or ATA card is full.
15	HEAD ERROR		•	z	•	There is a problem with the print head.	Yes	Yes
16	Display of error		•	z	•	A command error has occurred in	Yes	Yes
	message (See Notes.)					analyzing the command.

A2- 1