COPY FUNCTIONS
Copying from the ADF
1 Make sure that an original has not been left on the document glass. Close the ADF.
2 Adjust the original guides to the size of the original(s).
3 Set the original(s) face up in the document feeder tray.
5 | Press the [START] key ( ) to begin |
| copying. |
The copy is delivered to the paper output tray.
•The paper output tray can hold up to 250 
Note sheets of paper.
•About one minute after copying ends,
"Auto clear" activates and restores the | 2 |
copy settings to the initial settings. (p.12) | |
The setting for "Auto clear" time can be | |
changed in the user programs. (p.33) |
•Press the [CLEAR] key (
) to stop copying in the middle of a run.
•If you find it difficult to remove the original from the document feeder tray, open the feeding roller cover first and then remove the original. If you remove the original without opening the feeding roller cover, the original may become dirty.
●Insert the original into the document feeder tray as far as it will go. When the original is set, the ADF indicator will light up.
●The ORIGINAL SIZE indicator corresponding to the size of the original lights up.
●If the ORIGINAL SIZE indicator is blinking, rotate the original so that it is in the same orientation as the blinking ORIGINAL SIZE indicator.
●Make sure that the PAPER SIZE indicator is lit.
●If the indicator is not lit, no tray has the same size of paper as the original. Load paper of the required size in a tray, or select the bypass tray with the
[TRAY SELECT] key (
) and copy from the bypass tray.
●The bypass tray must be manually selected.
●To copy on paper of a different size than the original, select the paper with the [TRAY SELECT]
key (
).
Do not place originals of different sizes 
Note together in the document feeder tray. This
may cause misfeeds.
4 Set the number of copies.
19