Toshiba 200L, 280, 230L, 3511, e-Studio 350 manual Center Margin, Outer Margin, Orientation

Option Value	Alternate	Description
	Value
left2right=on	ON	Select left to right page layout for booklet printing mode.
		This is the default setting.
		If the value is ON then the layout of the pages is from Left to
		Right as shown in the figure below.

If left2right=off then long edge binding is selected, otherwise if left2right=on then short edge binding is used.

Example: The command to select left to right page layout for booklet printing mode is “lp –o left2right=on filename”.

— Center Margin

The booklet mode center margin can be selected using the following options.

Option Value	Alternate	Description
	Value
centermargin		Select the center margin value for booklet printing mode.
=value		This value specifies in pixels the Center Margin or the “Gutter”.
		This is in addition to the center margin already specified by the
		application. The valid range for value is 0 – 300. Default is 0.

Example: The command to select the center margin value for booklet printing mode is “lp –o centremargin=value filename”.

— Outer Margin

The booklet mode outer margin can be selected using the following options.

Option Value	Alternate	Description
	Value
outermargin		Select the outer margin value for booklet printing mode.
=value		This value specifies in pixels the Outer Margin or the “Creep”
		per page, which should take place while printing a booklet. The
		valid range for value is 0 – 18. Default is 0.

Example: The command to select the outer margin value for booklet printing mode is “lp –o outermargin=value filename”.

— Orientation

The following orientation options are available.

Option Value	Alternate	Description
	Value
portrait		Print the document in portrait orientation.

318 Printing Guide — Printing from UNIX