Toshiba 1000 user manual Modifications

Page 62

3.Repair or replacement of a defective UPS, UPS part, and/or BATTERY does not extend the respective original warranty period. All defective UPS, UPS parts, and/or BATTERIES shall be the property of TIC upon replacement.

4.This warranty shall constitute the sole and exclusive remedy of all purchasers and users of the UPS, UPS part, and/or BATTERY. TIC’s responsibility for UPS, UPS Parts, and/or BATTERY shall not exceed one times the net UPS and/or BATTERY purchase price. TIC HEREBY EXPRESSLY

DISCLAIMS ALL OTHER EXPRESS, STATUTORY AND IMPLIED WARRANTIES, INCLUDING WITHOUT LIMITATION, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE.

PROCEDURE

User must contact TIC via e-mail upsservice@tic.toshiba.com, or phone 1-800-231-1412, no later than 90 days after User’s discovery of occurrence or defect in UPS, UPS part, and/or BATTERY but in no event after the expiration of the respective warranty period. Subject to the limitations of this policy and product type, TIC service or TIC service representative shall repair/replace the UPS/part warranted hereunder, without charge for material, labor (on-site except in cases presented herein). If TIC determines that the requested repair is not covered under this limited warranty policy, then TIC shall advise customer and quote cost of repair. Repair charges shall be based on service parts price and prevailing service charges at the time of repair.

If the case in process is a BATTERY (stand-alone and/or cabinet) TIC will use its published Battery Diagnostic Document to evaluate warranty applicability. First, TIC will make sure that the storage, maintenance, installation, and operating conditions were met; then the BATTERY capacity will be tested in accordance with the “performance test” guidelines IEEE STD 450. If the BATTERY fails to deliver 70% of its rated capacity it shall be deemed defective and be replaced. Either float or cyclic service will be used to determine the warranty credit (as per published Battery Diagnostic Document). The typical credit applied will be as in the table above.

MODIFICATIONS

No representative, salesperson, agent, distributor, or employee of TIC is authorized to modify any of the terms of this warranty, unless modifications are made in writing and signed by an authorized TIC officer.

THIS WARRANTY REPRESENTS THE ENTIRE AGREEMENT BETWEEN TIC AND USER WITH RESPECT TO THE SUBJECT MATTER HEREIN AND SUPERSEDES ALL PRIOR OR CONTEMPORANEOUS ORAL OR WRITTEN COMMUNICATIONS, REPRESENTATIONS, UNDERSTANDINGS OR AGREEMENTS RELATING TO THIS SUBJECT.

End User:

Model Number:

Serial Number:

Startup Date:

 

Warranty End Date:

37

Image 62
Contents 1000 &1000+ Series Important Notice Uninterruptible Power System Table of Contents Limitations and Exclusions Manual’s Purpose and Scope Page VII ICES-003 EMC StatementsFCC Part Declaration of Conformity Request General Safety Instructions Safety Alert Symbol / Signal WordsPage Special Symbols Important Safety Instructions Qualified Personnel only Qualified Personnel shallPage XVI Instructions Importantes Concernant LA Sécurité Conserver CES InstructionsInspection/Storage/Disposal Storage Maintenance DisposalInstallation Precautions Conductor Routing and Grounding Operating Precautions Maintenance Note Xxiv Introduction System DescriptionGeneral Description Efficiency Optimizer Function Auto-Restart Free Run ModeDiagnostic Tests System Configuration Storage ShippingPage UPS Frequency Converter Option InstallationEnvironment Rear Panel Views 1000VA 1500VA Tower Rear Panel 2000VA 3000VA Tower Rear Panel2400VA Tower Rear Panel 2400VA Power Wiring Options X1-N or N-X3 120V Half Load1000 1500 VA Rack mount 2U Rear Panel 2000 3000 VA Rack mount 2U Rear PanelVA Rack mount UPS 3U, Battery Pack 3U Rear Panel Example of Installation of Plug & Play products 2400 VA6000 VA Front Panel Settings HE Mode SET ON/OFFOutlet GROUP1/GROUP2 Computer and Alarm Connections RS-232 Standard Interface PortDB9 Male Connector Outline Facing connector Dry Contact Interface optional cardNetwork Transient Protector EPO Port emergency power offUSB Port Load SegmentsShutting Down the UPS User’s Guide to OperationsUPS Startup and Shutdown Starting the UPS Button OperationControl Panel Functions Control panels 1000/1500/2000/3000VA Normal DisplayLCD Message Description UPS ConfigurationsUPS Meters Display Page UPS Manual Test Audible AlarmsSilencing an Alarm Interpreting UPS MessagesTroubleshooting Alarm Description What You Should DoMaintenance Battery ServicingTechnical Specifications Power Range 1000-3000 VA 120Power Range 2400 VA 208/240 Power Range 6000 VA 208/240 Rackmount US 208/240V UT1G1G060C6RKB3 + UT1-BR-0607 GeneralEnvironment Power Range 1000-3000 VA 230 RKB2Backup Time at Partial Loads Warranty Information Uninterruptible Power SystemLimitations and Exclusions Modifications
Related manuals
Manual 54 pages 29.07 Kb Manual 2 pages 33.02 Kb