Page 2
NOTICE
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reason- able protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense. Changes or modifications not expressly approved by manufacturer for compliance could void the user’s authority to operate the equipment.
WARNING
“This Class A digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations.”
“Cet appareil numénque de la classe A respecte toutes les exigences du Règlement sur le matériel brouilleur du Canada.”
Copyright © 1999
by TOSHIBA TEC CORPORATION All Rights Reserved
570 Ohito, Ohito-cho, Tagata-gun, Shizuoka-ken, JAPAN
Contents
MA-186-100 Series
Page
Safety Summary
Safety Summary
Meanings of Each Symbol
Precaution
Table of Contents
Toshiba TEC
Introduction
Unpacking
Offz SET
Outline of Preparation Procedure Before Operating
REG
REG Offz SET
Appearance and Nomenclature
Control Lock
Control Lock and Control Keys
Control Keys
REG Key
Customer’s Display
Display
Operator’s Display
ALM
Numeric Display
Message Descriptors Triangular Lamps
OFF
Standard Keyboard Layout
Keyboard
Other Optional Keys
CID
Installing the Paper Roll
REG OFF
Duplicate Sheet Original Sheet
EO1-11115 MA-186-100 Series
Time and Date Setting
Time Setting or Adjustment
Date now set
Date Setting or Adjustment
REG OFF @/FOR AT/TL SET
04.- 15.- 9 05.- 28.- 9 00.9
Printing the Time and Date
Tax Table Setting
Displaying the Time
Setting Procedure
A single-tax area, the TX1/M key may be labeled as TX/M key
Setting Examples
To indicate that no breaks are entered
Ex Tax 1 Full Breaks
05.- 28.- 9 01.7
Ex Tax 1 a Break and % Rate Combination
Ex Tax 1 % Rate only
05.- 28.- 9 10. % 01.8
01.5
GST/M
Thank you
Tax 1 memory
Non-taxable Limit Amount Setting
05.- 28.- 9 20.0 02.4
Taxable Limit Amount programmed
Tax Calculation Test
Optional Key Setting
Operating Procedure
List of Keys
Receipt Issue Post-receipt
Department Keys 1 to
Refer to the List Keys on the pre Ceding For the Standard
Key Installation Setting
REG OFF AT/TL SET Blind
Keyboard Layout Refer to Chapter
Issue without entering numbers
That the setting operation is completed. No printing occurs
Plan before starting the setting procedure
Receipt Issue Post-receipt Key
During Business Hours
Daily Operation Flow
Before Opening the Store
After Closing the Store
Entries in Training Mode
Training
41.3
Setting Preparation of Each Key and Transaction Entries
Receipt-issue/Non-issue Selection
41.4
Combination of 6 +
Thank you ←
No-sale Exchange
Void
10.2
Received-on-Account Payment
12.5 10.3
Programming Department Keys
Paid Out
Department Keys
10.4
Programming Procedure
Department Status Programming
Payment of electricity and gas, and donation
DP Amount
Be entered within one sale receipt sequence
00.5
Department Status Program Receipt Format
TX1/M TX2/M
01.1
Department LC Listing Capacity Programming
Department LC Program Receipt Format
Last setting is effective
Department Preset Price Setting
Department Preset Price Setting Receipt Format
05.- 28.- 9 34.5 02.0
Repeat Entry
Sale Item Entries Using Department Keys
Entry of One Item
Item of the Department Nos to
Quantity Extension Multiplication
Repeat
Split-Package-Pricing Department SPP
Other Income Department Entry
PLU Price-Look-Up PLU Key
Single-item Department Entry
10.0 10.5
Programming PLUs PLU Table Setting
Dept
AMT
Deleting Individual PLUs
PLU Table Program Receipt Format
05.- 28.- 9 00.7
PLU Preset Price Changing
PLU Deletion Receipt Format
OFF PLU #/CID
PL01.1 23.4 02.1
PLU Price Change Setting Receipt Format
Sale Item Entries of PLUs
@/FOR AMT
40.0
Single-item PLU Entry
Listing Capacity Open
Percent Charge, Percent Discount
28.- 9 PL10.1 10.7
05.- 28.- 9 01.4
Key Preset Rate Setting or Changing
05.- 28.- 9 10. % + 01.3
15.0
Key Operations in Sale Entries
6.0
Dollar Discount
Item Correct Last Line Voiding
Repeat entry is not possible using the Void key
Void Designated Line Voiding
18.7
All Void Transaction Cancel
Returned Merchandise
23.0 0 0 #
Non-add Number Print
SET #/CID
22.9
Subtotal Read
Taxable Total Read
TAX
Manual Tax Entry
Finalizing a Sale
Media Total
11.8
Post-issue Receipt
Check Cashing Cashing Non-cash Media
Bit 3 on
Percent Charge
Tax Status Modification
TX/M
Percent Discount
To exempt the sale from all taxes
Tax Exemption
To exempt the sale from designated taxes
Tax / PST
Print/Non-print Options on Sale Receipts
Tax / PST and GST
Programming Hourly Range Table
Read and Reset Reports
Programming Operations Relating to Reports
Refer to Note on Condition on
05.- 28.- 9 01.0
Selecting Print/Non-print Items on Reports
Programming Example
Report Taking Operation
Taking Read and Reset Reports
Fundamental Concepts of Various Types of Reports
Report Sample Format
Daily Reports
Periodical Reports
Report Name Key Operation
05.7 42.7 31.0 12.0 75.5 10.0
Financial Read or Reset Report Daily or Periodical
05.7
20.7
14.0
00.0
Gross Sale
Memory Balance
Grand Total
Net Sale with Tax
Daily All PLU Read or Reset Report Thank you Call again
Daily Hourly Sales Read or Reset Report
Daily PLU Read or Reset Report All or Zone
Daily Zone PLU Read or Reset Report
Daily Media Sales & In-drawer Read Report
Cashier Read or Reset Report Daily or Periodical
Daily Cashier Read or Reset Report Thank you Call again
05.0
Daily Individual Department Read Report
33.4
10.0 00.0 10.0 67.1 32.2
SET @/FOR
System Option Setting
Programming Procedure
Address 1 refer to the next
05.- 28.- 9 01.2
Your Selection →
Address
Non-print Options
Vacant
Supplementary Description for Address
Optional Functions
Disc or Void key
Register. Refer to on page 82 for
Addresses 4, 5 are vacant
Tax Status
Vacant Supplementary Description for Address
AT/TL Key Function
Total
Over-tendering tendering an amount larger than the sale
CHK TND Key Function Bit Content Selective Status
Vacant Cashing with no purchase, using this key
Prohibited
Reset
Chg Key Function
Allowed Prohibited
Address 12 is vacant
Address 1
TL, CHK TND, Chg
Separate
Line Print Lines
GST Options ... for Canada
Initial SET Bit Nos
Your Selection
Taxable Total
Resettable
Subtotal
ANY Number Only Once
Times
Cashier Sign on & Sign OFF
Cashier Signing Operation optional function
Programming Requirements
10.1
Cashier Reports
Near-Full Warning in REG Mode
Electronic Journal E.J. Print optional function
Programming Requirement
Operation
Reading of the Remaining Lines of E.J. Memory
Electronic Journal Report
OFF SET
32.0
10.1 10.2
PL20.0 10.0 18.7 12.7
Operating Procedure
Program Data Verification
66.6 01.7
Department Preset Price Read
Department LC and Status Read
PLU Table Read
Other Programmed Data Read
System Option Read
02.2
Paper Roll Replacement and Other Maintenance
Replacing the Paper Roll When used for receipt
Replacing the Paper Roll When used for journal
EO1-11115 MA-186-100 Series
Replacing the Ink Ribbon
REG7 Offz SET
Replenishing Ink to the Store Name Stamp
Allow time for ink to saturate the stamp
Manual Drawer Release and Lock
Battery Exchange
Removing the Drawer
Changing the Layout of the Money Case
Media Slot
Trouble concerning Power Supply Power is not turned on
Case of the Power Failure
Troubleshooting
Been selected. . System Option Setting, Address 2 Bit 7 on
Printing as a whole is too light
Paper roll wrinkles
Printer prints nothing
Printing gets stained
Trouble during Normal Operations
Trouble concerning Drawer Drawer does not open
Trouble concerning Display Display displays nothing
Normal operations cannot be carried out
System Option Setting, Address 2 Bit 8 on
Error tone beeps
Setting, Address 16 Bit 1 on
Bit 1 on
Status Clear
Operating Procedure
Status Clear and Memory Clear Operations
27.1
05.- 28.- 9 00.1
Sales Memory Clear
OperationX
An All Memory Clear receipt is issued
All Memory Clear
Amount and Counter Totals in Report Memory
Specifications
Size of Paper Roll
Specifications are subject to change without notice
Memory Protection
Toshiba TEC Model MA-186-100
Date
Company Name Address City Country Your Name Phone ZIP Code
Unit Price QTY Amount Stamp
EO1-11115 MA-186-100 Series
Page
Page
TEC