Installation
8.Fasten inner members pulled from the bracket assemblies in Step 2 to the UPS on both sides with eight M4 screws provided in this kit. Make sure that the retaining latch is near the rear of the UPS, as shown in Figure 14.
Figure 14 Installing inner members
Liebert GXT3 UPS
Inner Member
Retaining Latch
M4 screw, 8 pieces
9.Use M4 screws to install ears of accessories on both sides of the UPS, as shown in Figure 15.
Figure 15 Installing rack-mount ears
Liebert GXT3 UPS
Ear, 2 pieces
M4 Screw, 8 pieces
10.Insert the UPS, with inner members attached, into bracket assemblies by inserting top and bottom edges of inner members into the top and bottom curved tracks of front members and sliding the UPS into the rack, as shown in Figure 16.
Figure 16 Insert the UPS
Insert
Front Member
Inner Member
NOTE
Ends of inner members are tapered to allow the rear of the UPS to be angled upward before insertion, if space allows.
The UPS should move smoothly into the bracket assemblies. If not, recheck alignment of front and rear members from Steps 4 through 7.
Liebert® GXT3™ | 14 |