Installation
Figure 11 Installing rear member of each bracket assembly
Vertical pole |
M5 screw (4 pcs) |
Rear member |
Front member |
5.Extend bracket assembly by sliding the front member forward until it touches the rack’s front vertical rails (adjustable length: 18 inches to 32 inches).
6.Use two M5 screws to attach each front member onto the front vertical rails through the installation holes. Make sure that the bracket assemblies are at the same mounting height on all four of the rack’s vertical rails (see Figure 12.)
Figure 12 Installing front member of each bracket assembly
| e |
| d |
| li |
Front vertical pole | S |
| |
Front member |
|
M5 screw (4 pcs) | Rear member |
|
7.Fasten the rear and front members together using four M4 screws and four M4 nuts (M4 nuts have been installed on the rear member before delivery) per bracket assembly, as shown in Figure 13.
Figure 13 Fastening rear member and front member together
Rear member |
M4 screw (8 pcs) |
M4 nut (8 pcs) |
Front member |
13 | Liebert® GXT3™ |