Airlink101 AR570W user manual Federal Communication Commission Interference Statement

Page 2

Federal Communication Commission

Interference Statement

FCC Part 15

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

1.Reorient or relocate the receiving antenna.

2.Increase the separation between the equipment and receiver.

3.Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

4.Consult the dealer or an experienced radio technician for help.

FCC Caution

This equipment must be installed and operated in accordance with provided instructions and a minimum 20 cm spacing must be provided between computer mounted antenna and person’s body (excluding extremities of hands, wrist and feet) during wireless modes of operation.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Any changes or modifications not expressly approved by the party responsible for compliance could void the authority to operate equipment.

Federal Communication Commission (FCC) Radiation Exposure Statement

This equipment complies with FCC radiation exposure set forth for an uncontrolled environment. In order to avoid the possibility of exceeding the FCC radio frequency exposure limits, human proximity to the antenna shall not be less than 20cm (8 inches) during normal operation.

The antenna(s) used for this transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

The equipment version marketed in US is restricted to usage of the channels 1-11 only.

Image 2
Contents Wireless N 150 Router Federal Communication Commission Interference Statement Table of Contents Troubleshooting Technical Support Router Interface FeaturesPackage Contents Back Panel WPS Installing the Router Using EZ Setup WizardPage Page Dynamic IP Cable Modem users Page Page Congratulations! Your router configuration has been finished Connecting to the Router Wirelessly Page Using Web Configuration Utility Page Current Time Setup WizardEnable NTP Update Time ZoneHost Name Time Server AddressDaylight Savings MAC AddressUser Name Primary DNSSecondary DNS Connection Type PasswordService Name Idle Time OutPptp Pptp GatewayConnection ID BEZEQ-ISRAELL2TP Gateway User Name Please input user name assigned by TelstraParameterDescription Channel Number Associated ClientsWPA2Mixed Page 2 LAN Network1 WAN 802.1d Spanning Tree IP addressSubnet Mask Dhcp ServerDhcp Client Start IP Enable Static Dhcp LeasesLease Time Dhcp Client End IPNAT / Static Routing Reset Enable Static RoutingDefault Gateway Destination LAN IPDynamic DNS Reset You can also click ‘Reset’ button unselect allDdns Account Password/KeyProvider Band WirelessBasic Settings Wireless Security Show Active ClientsSee 3.2.2.1 to 3.2.2.3 for each encryption type Enable 802.1x AuthenticationEncryption Key Format Default Tx KeyKey Length Encryption Key 1~4Pre-shared Key WPA Unicast Cipher SuitePre-shared Key Format Radius Server IP Address Radius Server PasswordMAC Control Radius Server PortClear Enable MAC ControlComment Advanced Settings Fragment ThresholdBeacon Interval Tx PowerRTS Threshold Dtim Period5 WPS Page Config Mode Enable WPSWi-Fi Protected Setup Information Configure by Push Button Configure by Pin CodeApplication & Gaming Virtual Server Port ForwardingCurrent Virtual Server Table Special Applications Port TriggeringPublic Port Popular Application Enable Special ApplicationsTCP/UDP Port to Open Add in red box3 DMZ Client PC IP address Enable DMZPublic IP Current DMZ TableALG Settings Reset You can also click ‘Reset’ button to unselect all5 QoS Total Upload Bandwidth Enable QoSTotal Download Bandwidth Current QoS TableLocal IP Address Rule NameBandwidth Local Port RangeProtocol 1 IP & Port Filtering Access RestrictionsEnable IP & Port Filtering Deny/AllowPort Range Client ServiceClient PC Description MAC Filtering Client PC MAC Address Enable MAC Filtering3 URL/Keyword Filtering Current MAC Filtering TableCurrent URL Blocking Table Enable URL FilteringURL/Keyword Security FirewallDoS Denial-of-Service Ping of Death Pptp pass through VPN Pass throughIPsec pass through L2TP pass throughAdministration TimeConfirmed Password Current PasswordNew Password ManagementReset Reboot Remote Management Firmware Upgrade Restore Settings Configuration SettingsBackup Settings Restore to Factory DefaultRefresh 6 LogSave Statistics Internet Connection Status Wlan Wireless LAN StatusStatus LAN StatusSystem Status Troubleshooting Technical Support