Radio Shack PRO-433 quick start Scan

Page 14

The Basics

DATA

Appears when the data skip function is active, and in the trunking mode when the dis connect tone detect function is off.

Appears when Signal Stalker I is active.

SCAN

Appears during channel scan.

LIST

Appears with numbers (1–5) during trunking. A bar indicates which ID scan list banks are turned on for scanning.

SRCH

Appears during chain, direct, and ID searches.

SVC

Appears during Service Search mode.

PRI

Appears when the priority feature is turned on.

HOLD

Appears during chain, direct, service, and ID searches, and ID monitor holds, and ﬂashes while the scanner is temporarily monitoring a programmed ID.

DLY

Appears when you select a Delay option.

L/O

Appears when you manually select a locked out channel and talk group.

M-LOCK

Appears when you select a memory lock option.

Appears when you select a Skywarn channel.

PGM

Appears while you store a frequency into a channel, enter a frequency range during a chain search, or program trunking frequencies, ﬂeet maps, or ID memories while trunking.

14

Image 14

Contents PRO-433 1,000 ch Trunking Desktop/Mobile Scanner Quick StartBeyond the basics Contents Quick startBasics Trunking operationsCare ContentsSpecial features Base station Installing your scannerQuick start Vehicle mountingWall outlet Power your scannerWhen mounting in your dashboard, you will need to Vehicle fuse box, use a certiﬁed installer Vehicle cigarette lighter or power portIf you are not experienced in connecting accessories to Connect your scannerExternal speaker Connecting an external speaker mutes the scanner’sAntenna Internal speakerStoring frequencies in channels Quick Start Setting up your scannerTurning on your scanner Copying / moving frequenciesSearching for frequencies Monitoring Earphones / headphonesQuick Start Monitoring and scanning ScanningBasics Basics Your scanner’s controls TrunkYour scanner’s display PGMScan Replacing the fuse Channel-storage banks Appears when you activate the priority featureBeyond the basics Priority channelsBeyond the Basics Chain search At least one bank must be active. If you disable allBanks, the error tone beeps Weather search and alert Service bank searchIt can take several minutes to search all the service Fips codes Beyond the Basics Skywarn Beyond the Basics Signal Stalker Turn off the data skip feature if it is onData skip Keytones DelayUsing the memory lock does not prevent the scanner from Memory lockTrunking operations Programming trunked frequenciesTalk group ID Storing talk group IDsOne of the ten scan lists must always be active. You Scanning a talk group ID listLocking out a talk group ID Cannot remove all of themLocked out Priority talk group ID scanningMonitoring a talk group ID Trunking Operations AFS Format Talk group ID search range EdacsYou cannot use partial talk groups in decimal mode Status Bit S-Bit IgnoreTrunking Operations Trunk search and scan Type I and hybrid trunked systemsPreset ﬂeet maps Programming a ﬂeet map Enter size code S-0 Programming base and offset frequenciesFor Motorolla Type II, instead of selecting the size block Motorola disconnect tone detect function PC programming Special featuresSeconds, T-Err appears and wired programming stops Scanner cloningSpecial Features Troubleshooting CareTo ensure that the scanner clears its memory properly Resetting the scannerService and repair Leave it on until CLEAr stops ﬂashingSpeciﬁcations SpeciﬁcationsUBZZ01345ZA0