Radio Shack PRO-433 quick start Searching for frequencies

Page 9

Quick Start

4. Select the target bank. The smallest empty channel number ﬂashes over the frequency.

5.	Press or to access the target channel.
6.	Press E/PGM. If there is no empty channel, the scanner
	automatically selects the ﬁrst channel of the bank.

To cancel the copy or move, press . /CLR /DELAY.

searching for frequencies

You can search for frequencies up or down using direct search.

1. Press and hold SRCH. SRCH appears in the display.

2. (Optional) To set a starting frequency, press HOLD and enter the frequency.

3. Press or to begin searching up or down the frequencies.

4. (Optional) To avoid unwanted frequencies, you can skip up to 200 speciﬁed frequencies during a search. To skip a frequency, press L/O when the scanner ﬁnds the frequency.

	• You cannot skip frequencies during a weather service
NOTES	search.
NOTES	• If you skip all frequencies within the search range, the
	scanner cannot search.
	• If you try to skip more than 200 frequencies, the
	scanner will stop skipping the earliest skipped
	frequencies.

To clear a skipped frequency, complete the following steps:

1. Press HOLD/RESUME to stop the search.

2. Select the frequency. L/O appears.

3. Press L/O. L/O disappears.

4. (Optional) To clear all the skipped frequencies, press HOLD/ RESUME, then hold down L/O until the scanner beeps twice.

9

Image 9

Contents Quick Start PRO-433 1,000 ch Trunking Desktop/Mobile ScannerBasics Contents Quick startBeyond the basics Trunking operationsContents Special featuresCare Quick start Installing your scannerBase station Vehicle mountingPower your scanner When mounting in your dashboard, you will need toWall outlet If you are not experienced in connecting accessories to Vehicle cigarette lighter or power portVehicle fuse box, use a certiﬁed installer Connect your scannerAntenna Connecting an external speaker mutes the scanner’sExternal speaker Internal speakerTurning on your scanner Quick Start Setting up your scannerStoring frequencies in channels Copying / moving frequenciesSearching for frequencies Quick Start Monitoring and scanning Earphones / headphonesMonitoring ScanningBasics Trunk Basics Your scanner’s controlsPGM Your scanner’s displayScan Replacing the fuse Beyond the basics Appears when you activate the priority featureChannel-storage banks Priority channelsAt least one bank must be active. If you disable all Banks, the error tone beepsBeyond the Basics Chain search Service bank search It can take several minutes to search all the serviceWeather search and alert Fips codes Beyond the Basics Skywarn Turn off the data skip feature if it is on Beyond the Basics Signal StalkerData skip Using the memory lock does not prevent the scanner from DelayKeytones Memory lockProgramming trunked frequencies Trunking operationsStoring talk group IDs Talk group IDLocking out a talk group ID Scanning a talk group ID listOne of the ten scan lists must always be active. You Cannot remove all of themPriority talk group ID scanning Monitoring a talk group IDLocked out Talk group ID search range Edacs Trunking Operations AFS FormatStatus Bit S-Bit Ignore You cannot use partial talk groups in decimal modeType I and hybrid trunked systems Trunking Operations Trunk search and scanPreset ﬂeet maps Programming a ﬂeet map Programming base and offset frequencies For Motorolla Type II, instead of selecting the size blockEnter size code S-0 Motorola disconnect tone detect function Seconds, T-Err appears and wired programming stops Special featuresPC programming Scanner cloningSpecial Features Care TroubleshootingService and repair Resetting the scannerTo ensure that the scanner clears its memory properly Leave it on until CLEAr stops ﬂashingSpeciﬁcations SpeciﬁcationsUBZZ01345ZA0