Radio Shack PRO-433 quick start Data skip

Page 22

Beyond the Basics

S-S.ALt

Alert settings

S-S.Lit

Back light settings

S-S.PS

Pager screen settings

S-S.OnlY

Mode settings

 

To turn off normal scanning, when Signal Stalker I is

 

running, turn S-S.OnlY setting to ON.

S-S.Int

Voice interrupt settings

 

To keep Signal Stalker I active while receiving an audio

 

signal, set this function to ON. If you turn this function

 

OFF, the scanner does not check signals while receiving

 

an audio signal.

S-S.LOG

............................................................................Logging settings

Set S-S.LOG to ON to scan the log channels along with the normal channels.

4. For other settings, press or to select ON or OFF, then press

E/PGM.

5. Press . /CLR /DELAY to exit the option mode.

6. Press MENU to exit the menu mode.

data skip

Data skip prevents the scanner from stopping on nonmodulated or data signals (such as fax or modem transmissions) during a search or scan.

Data skip does not apply to the air band and weather NOTE search mode, as data signals are not generally found in

these services.

To turn on the data skip feature, complete the following steps:

1. Turn off the priority feature if it is on.

2. Press MENU.

3. Repeatedly press or to display dAtA-S, then press E/PGM.

4 . Press or to select OFF or ON, then press E/PGM.

22

Image 22
Contents PRO-433 1,000 ch Trunking Desktop/Mobile Scanner Quick StartBeyond the basics Contents Quick startBasics Trunking operationsSpecial features ContentsCare Base station Installing your scannerQuick start Vehicle mountingWhen mounting in your dashboard, you will need to Power your scannerWall outlet Vehicle fuse box, use a certified installer Vehicle cigarette lighter or power portIf you are not experienced in connecting accessories to Connect your scannerExternal speaker Connecting an external speaker mutes the scanner’sAntenna Internal speakerStoring frequencies in channels Quick Start Setting up your scannerTurning on your scanner Copying / moving frequenciesSearching for frequencies Monitoring Earphones / headphonesQuick Start Monitoring and scanning ScanningBasics Basics Your scanner’s controls TrunkYour scanner’s display PGMScan Replacing the fuse Channel-storage banks Appears when you activate the priority featureBeyond the basics Priority channelsBanks, the error tone beeps At least one bank must be active. If you disable allBeyond the Basics Chain search It can take several minutes to search all the service Service bank searchWeather search and alert Fips codes Beyond the Basics Skywarn Beyond the Basics Signal Stalker Turn off the data skip feature if it is onData skip Keytones DelayUsing the memory lock does not prevent the scanner from Memory lockTrunking operations Programming trunked frequenciesTalk group ID Storing talk group IDsOne of the ten scan lists must always be active. You Scanning a talk group ID listLocking out a talk group ID Cannot remove all of themMonitoring a talk group ID Priority talk group ID scanningLocked out Trunking Operations AFS Format Talk group ID search range EdacsYou cannot use partial talk groups in decimal mode Status Bit S-Bit IgnoreTrunking Operations Trunk search and scan Type I and hybrid trunked systemsPreset fleet maps Programming a fleet map For Motorolla Type II, instead of selecting the size block Programming base and offset frequenciesEnter size code S-0 Motorola disconnect tone detect function PC programming Special featuresSeconds, T-Err appears and wired programming stops Scanner cloningSpecial Features Troubleshooting CareTo ensure that the scanner clears its memory properly Resetting the scannerService and repair Leave it on until CLEAr stops flashingSpecifications SpecificationsUBZZ01345ZA0