Radio Shack PRO-433 quick start Special features, PC programming, Scanner cloning

Page 35

Special Features

special features

PC programming

You can transfer programming data to your scanner using your PC and an optional interface cable and software (available at your local RadioShack or www.radioshack.com).

1. Turn off your scanner.

2. Connect the interface cable to your computer and then connect the other end of the cable to the scanner’s PC/IF port.

3. Install the software to your computer and run the program.

4. To set up the program, click on Tools, select Conﬁguration, and select PRO-433 (if necessary).

5. Turn the scanner on. PGM and WirEd appear automatically.

6. Send the data from the PC. Data frame numbers being received appear.

	NOTE	If the scanner receives no data from the PC for more than
	NOTE	20 seconds, T-Err appears and wired programming stops.
		20 seconds, T-Err appears and wired programming stops.

When the scanner has successfully received all data, End appears. If the scanner received an error while receiving data, End, d-Err, and its frame number appear. C-Err indicates the packet number where a communication error occurred. S-Err indicates the packet number where a checksum error occurred. L-Err indicates the packet number where a length ﬁeld error occurred.

scanner cloning

You can clone all the frequencies, trunking talk groups, and ﬂeet maps programmed in your PRO-433 to another PRO-433 or PRO- 528 using an optional interface cable (available at your local RadioShack or www.radioshack.com).

1. Turn off your scanner.

35

Image 35

Contents Quick Start PRO-433 1,000 ch Trunking Desktop/Mobile ScannerTrunking operations Contents Quick startBasics Beyond the basicsCare ContentsSpecial features Vehicle mounting Installing your scannerQuick start Base stationWall outlet Power your scannerWhen mounting in your dashboard, you will need to Connect your scanner Vehicle cigarette lighter or power portIf you are not experienced in connecting accessories to Vehicle fuse box, use a certiﬁed installerInternal speaker Connecting an external speaker mutes the scanner’sAntenna External speakerCopying / moving frequencies Quick Start Setting up your scannerTurning on your scanner Storing frequencies in channelsSearching for frequencies Scanning Earphones / headphonesQuick Start Monitoring and scanning MonitoringBasics Trunk Basics Your scanner’s controlsPGM Your scanner’s displayScan Replacing the fuse Priority channels Appears when you activate the priority featureBeyond the basics Channel-storage banksBeyond the Basics Chain search At least one bank must be active. If you disable allBanks, the error tone beeps Weather search and alert Service bank searchIt can take several minutes to search all the service Fips codes Beyond the Basics Skywarn Turn off the data skip feature if it is on Beyond the Basics Signal StalkerData skip Memory lock DelayUsing the memory lock does not prevent the scanner from KeytonesProgramming trunked frequencies Trunking operationsStoring talk group IDs Talk group IDCannot remove all of them Scanning a talk group ID listLocking out a talk group ID One of the ten scan lists must always be active. YouLocked out Priority talk group ID scanningMonitoring a talk group ID Talk group ID search range Edacs Trunking Operations AFS FormatStatus Bit S-Bit Ignore You cannot use partial talk groups in decimal modeType I and hybrid trunked systems Trunking Operations Trunk search and scanPreset ﬂeet maps Programming a ﬂeet map Enter size code S-0 Programming base and offset frequenciesFor Motorolla Type II, instead of selecting the size block Motorola disconnect tone detect function Scanner cloning Special featuresSeconds, T-Err appears and wired programming stops PC programmingSpecial Features Care TroubleshootingLeave it on until CLEAr stops ﬂashing Resetting the scannerService and repair To ensure that the scanner clears its memory properlySpeciﬁcations SpeciﬁcationsUBZZ01345ZA0