Radio Shack PRO-433 quick start Special Features

Page 36

Special Features

2. Connect the interface cable into each scanner’s PC/IF port.

3. While you press and hold E/PGM on both scanners, turn on both scanners.

4. Determine the scanner which has the frequency data that you want to transfer. This one must be set up as the First Unit, and the other must be set as the Clone Unit

5. Press E/PGM on the First Unit and then the Clone unit. The First Unit checks whether the Clone unit is connected correctly. When a First Unit receives the response from the Clone unit, the data transfer starts. During data transfer, SND and REC ﬂashes.

6. When the data transfer is completed, donE appears. If the data transfer is not successful, Error appears.

7. After the clone operation is complete, remove the cable, turn both units off and then on again.

36

Image 36

Contents PRO-433 1,000 ch Trunking Desktop/Mobile Scanner Quick StartContents Quick start BasicsBeyond the basics Trunking operationsContents Special featuresCare Installing your scanner Quick startBase station Vehicle mountingPower your scanner When mounting in your dashboard, you will need toWall outlet Vehicle cigarette lighter or power port If you are not experienced in connecting accessories toVehicle fuse box, use a certiﬁed installer Connect your scannerConnecting an external speaker mutes the scanner’s AntennaExternal speaker Internal speakerQuick Start Setting up your scanner Turning on your scannerStoring frequencies in channels Copying / moving frequenciesSearching for frequencies Earphones / headphones Quick Start Monitoring and scanningMonitoring ScanningBasics Basics Your scanner’s controls TrunkYour scanner’s display PGMScan Replacing the fuse Appears when you activate the priority feature Beyond the basicsChannel-storage banks Priority channelsAt least one bank must be active. If you disable all Banks, the error tone beepsBeyond the Basics Chain search Service bank search It can take several minutes to search all the serviceWeather search and alert Fips codes Beyond the Basics Skywarn Beyond the Basics Signal Stalker Turn off the data skip feature if it is onData skip Delay Using the memory lock does not prevent the scanner fromKeytones Memory lockTrunking operations Programming trunked frequenciesTalk group ID Storing talk group IDsScanning a talk group ID list Locking out a talk group IDOne of the ten scan lists must always be active. You Cannot remove all of themPriority talk group ID scanning Monitoring a talk group IDLocked out Trunking Operations AFS Format Talk group ID search range EdacsYou cannot use partial talk groups in decimal mode Status Bit S-Bit IgnoreTrunking Operations Trunk search and scan Type I and hybrid trunked systemsPreset ﬂeet maps Programming a ﬂeet map Programming base and offset frequencies For Motorolla Type II, instead of selecting the size blockEnter size code S-0 Motorola disconnect tone detect function Special features Seconds, T-Err appears and wired programming stopsPC programming Scanner cloningSpecial Features Troubleshooting CareResetting the scanner Service and repairTo ensure that the scanner clears its memory properly Leave it on until CLEAr stops ﬂashingSpeciﬁcations SpeciﬁcationsUBZZ01345ZA0