Yamaha DPX-1200 manual Setup

Menu items

◆ Setup

Location	Designate the location of the main unit.
	Choices: [Front/Table] [Front/Ceiling] [Rear/Table] [Rear/Ceiling] (☞ page 50)
Keystone Correction	Adjusts the projection angle of the image.
	If you do not install the projector at right angles to the screen, the image will be trapezoidally
	distorted. You can electronically correct this distortion using the keystone function to adjust the
	width without changing the height of the image. Increase the keystone value (0 to 100) when the
	top of the image is overly wide, and reduce it (-100 to 0) when the lower part is overly wide.
	When the upper part of			When the lower part of
	the image is wider than the lower		the image is wider than the top
	Increase the value				Decrease the value
	in the positive (+) direction		in the negative (-) direction
Remote Control Sensor	Sets the remote control sensor.
	The main unit has two remote control sensors, one on the front panel and one on the rear,
	which this setting allows you to switch between. The remote control functions regardless
	of the setting of this parameter if you use a wired connection to connect it to the main unit.
	Choices: Front & Rear/Front/Rear/Off
Remote Control ID	Sets the remote control ID.
	Selects ID1 or ID2 for each main unit when operating two main units with one remote
	control. You can select the controllable main unit with the remote control code switch on
	the remote control.
	Choices: ID1/ID2
Lens Adjustment Lock	Locks the lens adjustment function.
	Locks the lens so that you cannot change the V.POS, ZOOM, and FOCUS settings
	accidentally when set to [ON]. Set to [OFF] to cancel this function.
Lamp Power	Lowers the power supply to the lamp.
	You can adjust the power supplied to the lamp within the range of 80 to 100%.
Menu Color	Selects the color of the letters and background the main unit uses to display
	the menu on screen.
	You can choose to display the menu screen in [Monotone] or [Color]. Also, you can adjust
	the contrast and brightness of the menu from the [Menu Brightness] and [Menu Contrast]
	menus. You can select from 3 color types.
	Monotone	Menu Brightness	Color			Menu Brightness
		Menu Contrast				Menu Contrast
						Color Style
Menu Mode	Switches menu modes between an easy-to-use basic mode and a detailed
	advanced mode.
	Choices: Basic/Advanced
Message	Selects whether to display memory number, input signal and other
	information on the projection screen. (☞ page 60)
	Choices: On/Off
Trigger Out	Sets the TRIGGER OUT terminal.
	Set the external control TRIGGER OUT jack 12 V signal emission to [Lamp] to
	synchronize it to the ON/OFF state of the lamp, to [Fan] to synchronize it to the fan, and to
	[RS-232C] to receive ON/OFF signals through the RS-232C terminal.
	Choices: Lamp/Fan/RS-232C
Baud Rate	Sets the transmission speed of the RS-232C terminal.
	This setting becomes valid from the next time you switch the unit on.
	Choices: 9600bps/19200bps/38400bps/57600bps/115200bps

7

Menu

31