Peerless Industries PRG-UNV-S, PRG-UNV-W manual Attaching Adapter Plate to Projector

Page 9

Attaching Adapter Plate to Projector

5NOTE:below. The projector you are installing may differ in appearance from the sample illustrated Place projector upside down. Locate adapter plate (B) with notch facing forward as close to projector center of gravity as possible without covering any mounting holes. Loosen channels with 4mm security allen wrench (I), and if there are only three mounting holes remove fourth channel. Using one channel for each mounting hole, position feet of channels over mounting holes as shown below. IMPORTANT: If projector does not have at least three mounting holes, do not use this adapter plate.

NOTE: Some projectors have feet which can be removed and the corresponding threaded insert can be used for a mounting hole.

NOTE: Once channels are in position retighten fasteners. *Notch indicates front of projector.

MOUNTING HOLE

 

CHANNEL

FOOT OF

 

CHANNEL

 

B

*

 

GENERIC PROJECTOR

 

9 of 51

ISSUED: 09-30-09 SHEET #: 056-9024-5 07-18-11

Image 9
Contents Max UL Load Capacity FeaturesTable of Contents Tools Needed for AssemblyPRG-UNV PRG-UNV-S PRG-UNV-W Parts ListSkip to step Installation to Extension Column/Ceiling PlateInstallation to Wood Joist Ceilings Installation to Concrete Ceilings View Not evaluated by UL Professional installation only Installation to Threaded RodAttaching Adapter Plate to Projector L or M Connection Block Cable Management Mount assembly to full upward tilt positionProjector Alignment Front View Ceiling Plates PRG Series Projector Mount AccessoriesCord Management Capacidad máxima de soportar carga CaracterísticasTabla de contenido Herramientas necesarias para el ensamblajeDescripción Cant. N.o de pieza De pieza Lista de piezasPase al paso Instalación en columnas de extensión / placas de techoInstalación en techos con vigas de madera Instalación en techos de concreto Vista EN Corte No evaluado por UL Instalación profesional solamente Instalación en varillas roscadasFijar la placa adaptadora al proyector Precaución 27 de Conéctelos al proyector Manejo de cableAlinear el proyector Vista Lateral Pieza adaptadora de techo para cerchas Accesorios del Soporte para Proyectores Serie PRGManejo de cables Caractéristiques Table des matières Outils nécessaires au montagePièce no Liste des piècesPassez à l’étape Installation à une colonne d’extension / plaque de plafondInstallation sur des plafonds à solives de bois Installation à un plafond en béton VUE EN Coupe Français Fixation de la plaque d’adaptation au projecteur Mise EN Garde Avertissement Reliez-les au projecteur Gestion des câblesAlignement du projecteur VUE DE Face Adaptateur de plafond à ossature apparente Accessoires du support de projecteur de la série PRGAlligator Limited FIVE-YEAR Warranty Garantía Limitada DE Cinco Años Garantie DE Cinq ANS