Brother HL-660 manual English

English

USER’S GUIDE

For errors shown below, the printer indicates an operator call by blinking the ALARM lamp and printing the error messages on paper.

Error	Action
Memory Full	∙ Press the FF/CONT switch to print the data
	remaining in the printer.
	∙ If you are using the supplied Windows driver, try
	again after changing the following settings. The
	best combination of the settings below varies
	depending on your document.
	Graphics Mode
	TrueType mode
	User Printer TrueType™ Fonts
	Page Protection
	∙ Expand the printer memory by adding a
	commercially available SIMM.
	∙ Reduce the print resolution or reduce the complexity
	of your document.
Print Overrun	∙ Press the FF/CONT switch to print the data
	remaining in the printer.
	∙ If you use the supplied Windows driver, try again
	after changing the following settings. The best
	combination of the settings below varies depending
	on your document.
	Graphics Mode
	TrueType mode
	User Printer TrueType™ Fonts
	Page Protection
	∙ If this does not clear the error, reduce the
	complexity of your document or reduce the print
	resolution.
	∙ Expand the printer memory by installing SIMM and
	set page protection ON by using the supplied
	Windows driver or RPC program.
Centronics	∙ Press the FF/CONT switch to resume printing.
Interface Line	∙ Check that the connection between your computer
Error	and printer is secure and correct, and check the
	interface cable.

✒Note

If the printer does not operate as you expect it to, it is recommended that you perform a user reset or factory reset with the switches or unplug the printer, wait a few seconds and then plug it in again. If you still have problems, consult your dealer or our authorized service representative.

6–2