Brother HL-660 manual Test Print Mode, Data

English

USER’S GUIDE

Test Print Mode

The printer has a test print mode where you can select and perform any of three test prints. Follow these steps:

1.Press the SELECT switch to turn the printer off-line.

2.Hold down the FF/CONT switch and press the SELECT switch.

The printer enters the test print mode. The ALARM lamp blinks to indicate that the first choice, Test sample page, is selected. See the table below.

3.Press the FF/CONT switch to select another test.

Every time you press the switch, the blinking lamp changes to select another choice. See the table below.

4.Press the SELECT switch to perform the selected choice.

Blinking Lamp	Choice	Function
ALARM	Test sample page	The printer prints a test
		sample page.

READY Print Fonts I & P

DATA Print Config

The printer prints a list of the internal or resident fonts of the printer. If permanent fonts are downloaded into the printer memory, the printer also prints a list of permanent download fonts.

The printer prints the current settings that configure or set up the printer.

MANUAL	Enable/disable the test	The test print set by TEST
	print	switch is enabled or disabled.

After printing the desired test sample page, the printer returns to the ready status.

3–6