Brother HL-4070CDW setup guide Choose Manual and then click Next

Installing the Printer Driver

Macintosh®

2

3

4

Click Wireless Network users.

Choose Wireless Setup and Driver Install, and then click Next.

Choose Manual and then click Next.

6

7

Connect the Brother wireless device to your access point using a network cable and click Next. Go to 11.

If you choose This computer has wireless capability., check I am using an access point in infrastructure mode, and then click Next. Go to 8.

5 For configuration, it is recommended that you temporarily connect your Brother wireless device (your printer) directly to a free port on your access point, hub or router using a network cable.

„If you can temporarily connect with a network cable:

Choose I’m able to temporarily connect my device to my access point with a network cable and then click Next. Go to

6.

„If you do not have a network cable or cannot temporarily connect the Brother wireless device to your access point:

Choose I’m not able to connect my device to my access point with a network cable and then click Next. Go to 7.

If you are using a wired computer, choose This computer uses a network cable to connect to the wireless network., you must configure the wireless settings from the control panel.

Click Next and follow the on-screen instructions to complete the setup. (See Chapter 3 in the Network User’s Guide on the CD-ROM.) When finished, go to Installing the printer driver on page 48 to install the printer driver.

Network

Wireless

Macintosh®

45