Panasonic UF-490 appendix Fax Parameter Table, Setting Comments Number, Off, Always

				Customizing Your Machine
Fax Parameter Table
No.	Parameter	Setting	Setting		Comments
		Number
01	CONTRAST	*1	Normal	Setting the home position for the CONTRAST.
		2	Lighter
		3	Darker
02	RESOLUTION	*1	Standard	Setting the home position for the RESOLUTION.
		2	Fine
		3	S-Fine
		4	Halftone
05	MEMORY	1	Off	Selecting the memory transmission mode.
		*2	On
06	DIALING METHOD	1	Pulse	Selecting the dialing method.
		*2	Tone
07	HEADER PRINT	*1	Inside	Selecting the printing position of the header.
				Inside : Inside TX copy area.
		2	Outside
				Outside : Outside TX copy area.
		3	No print	No print : Header is not printed.
08	HEADER FORMAT	*1	Logo, ID No.	Selecting the header format.
		2	From To
09	RCV’D TIME PRINT	*1	Invalid	Selecting whether the machine prints the received date &
				time, remote ID, percentage of reduction and page number
		2	Valid
				on the bottom of each received document.
10	KEY/BUZZER	1	Off	Selecting the volume of the Key/Buzzer tone.
	VOLUME
		*2	Soft
		3	Loud
12	COMM. JOURNAL	1	Off	Selecting the home position of printout mode for COMM.
				Journal Off/Always/Inc. only.
		2	Always
				Off	: Does not print
		*3	Inc. only	Always	: Always prints
				Inc. only : Prints only when communication has failed.
13	AUTO JOURNAL	1	Invalid	Selecting whether the machine prints the journal
	PRINT			automatically after every 32 transactions.
		*2	Valid
15	IN MODE	*1	Tel	Selecting IN (attended) mode as either Telephone Mode or
				Fax/Tel Auto Switching Mode.
		2	Fax/Tel SW
16	OUT MODE	*1	Fax	Selecting OUT (unattended) mode as either Fax Mode or
				TAM Interface Mode.
		2	TAM / Fax
18	OPERATOR CALL	*1	20 sec.	Selecting the length of time that your machine signals
	TIMER			(rings) for an incoming voice call in Fax/Tel Auto Switching
		2	30 sec.
				Mode. (See page 58)
		3	40 sec.
		4	50 sec.
19	OGM LENGTH	1	1 sec.	Setting for the OGM length of your TAM from 1 to 60
	(TAM I/F)			seconds. The machine will not start to detect SILENCE
		---	---
				until the time setting has lapsed.
		60	60 sec.	(Default = 20 sec.)
20	SILENT DETECTION	1	Invalid	Selecting the Silent Detection Mode.
	(TAM I/F)
		*2	Valid

Programming Your Machine

Continued on the next page... 33