Sharp FO-B1600 operation manual Material Safety Data Sheet 3/3

Page 114

S H A R P

Revised date: .

Issued date :Sep.19.2002

MATERIAL SAFETY DATA SHEET (3/3)

MSDS No. B-1028

Section 12. Toxicological Information

Acute Toxicity: Not expected to be acutely toxic; LD50 (oral, rat) expected to be >2000 mg/kg.

Chronic Toxicity: Not expected to be chronically toxic based on component information, volume, concentration, and intended use.

Pure carbon black, a minor component of this ink, has been listed by LARC as group 2B (possible carcinogen).

This classification is based on rat “lung particulate overload” studies performed with airborne particulate carbon black.Ink is not listed by LARC, NTP, or OSHA.

Carcinogenicity: OSHA Regulated(USA): Not listed

In 1996 the LARC reevaluated carbon black as a Group 2B carcinogen (possible human carcinogen). This evaluation is given to Carbon Black for which there is inadequate human evidence, but sufficient animal evidence. The latter is based upon the development of lung tumors in rats receiving chronic inhalation exposures to free carbon black at levels that induce particle overload of the lung.

Studies performed in animal models other than rats have not demonstrated an association between carbon black and lung tumors.

Section 13. Ecological Information

No data available.

Section 14. Disposal Consideration

This product is not a listed or hazardous waste in accordance with Federal Regulation 40 CFR Part 261. If discarded, this product would not be a hazardous waste either by listing or by characteristic. However, it is the responsibility of the product user to determine at the time of disposal whether a material has been contaminated and should be classified as a hazardous waste.

In accordance with RCRA 40 CFR Section 264.314 and 265.314, the placement of any liquid in landfills is prohibited.

Disposal is subject to local, state and federal regulations.

Section 15. Transport Information

DOT PROPER SHIPPING NAME: Not regulated as hazardous material.

Section 16. Regulatory Information

All ingredients are registered under the Toxic Substances Control Act (TSCA) or underpolymer exemption. All ingredients are exempt, registered or considered registered (polymers) under the European Inventory of Existing Commercial Chemical Substances(EINECS/ELINCS).

Preparation not classified as dangerous (EU Directive 67/548/EEC;1999/45/EC).

All ingredients are listed on or are considered polymers under the Canadian Domestic Substances List (DSL) or Non Domestic Substances List (NDSL).

Note of the product ingredients are listed as Emergency Planning and Community Right-to-Know Act (EPCRA)-Section 302: Extremely Hazardous Substances (EHS).

None of the product components are present above the minimum quantities of listed chemicals in EPCRA Section 313 Supplier Notification.

This product contains no known materials at levels which the State California has found to cause cancer, birth defects or other reproductive harm - California Proposition 65.

Section 17. Other Information

Restrictions: This information relates only to the specific material designated as supplied by the manufacturer. This information is supplied to us by the manufacturer and Sharp offers no warranties as to its accuracy and accepts no responsibilities for any typographical errors which may appear on these sheets. It is the responsibility of the user to determine the suitability of this product for each particular use.

Literature Reference:

LARC(1996): LARC monographs on the Evaluation of the Carcinogenic Risk of Chemicals to Humans, Vol.65, Printing Process and Printing Inks, Carbon Black and Some Nitro Compounds, Lyon, pp.149-261 H.Muhle, B.Bellmann, O.Creutzenberg, C.Dasenbrock, H.Ernst, R.Kilpper, J.C.MacKenzie, P.Morrow, U.Mohr, S.Takenaka, and R.Mermelstein(1991) Pulmonary Response to Toner upon Chronic Inhalation Exposure in Rats.

Fundamental and Applied Toxicology 17, pp.280-299

112

Image 114
Contents FO-B1600 About the Telephone Consumer Protection ACT Introduction VerticalPaper tray capacity Applicable telephone lineImportant safety information Page Table of Contents Printing Lists Maintenance Look at the Operation Panel COPY/HELP key Speaker keyHold key Stop keyInstallation Unpacking ChecklistRemoving the packing tape Points to keep in mind when setting upAttachments Open the print compartment coverConnecting the handset Close the printer coverAttaching the paper trays Installation1 Loading Printing Paper Place Connecting the Power Cord Installing the Print Cartridge Open the operation panelRemove only the tape from the the new cartridge Change Cartridge Installed is new Press OLD if the cartridge you Installed is oldPress NEW if the cartridge you Press Memory Setting the paper size Press Once Times Ink save modePress Press To turn on ink save mode, orConnecting the Telephone Line Cord Extension phone optional Remove the seal covering the TEL. SET jackConnect the extension phone line to the TEL. SET jack Entering Your Name and Fax Number Enter your fax number by pressing the number keys max digits Setting the Date and Time Press once and 3 timesDaylight Saving Time Setting the Reception Mode Setting the reception modeMode Speaker Volume AdjustmentDesired volume level Press To selectRinger When talking through the handset Press To selectHandset If you selected Ringer OFF OK ? toSize and weight Sending FaxesTransmittable Documents Loading the Document Other restrictionsRemoving a document from the feeder Open the operation panel Remove the documentAdjusting the Resolution and Contrast Resolution settingsContrast settings Press RESOLUTION/ one or more times Load the documentsChanging the default resolution Sending a Fax by Normal Dialing Sending a Fax by Automatic Dialing Sending a Fax by Automatic DialingPress Function once Once Storing fax and phone numbers for automatic dialingRapid Keys If you know the Speed Dial number thatMemory Date and time display Editing and clearing auto-dial numbersReturn to to store another number, or press to return to Press 1 for Edit or 2 for ClearPress Memory Make the desired changes to the name To the date and time displayUsing a Rapid Key for a voice call Rapid Key DialingLoad the documents If desired, press Using a Speed Dial number for a voice call Speed DialingMemory . If not, press Repeat Step Searching for an auto-dial number Press Until the name of the other party appearsDisplay if no name was stored, the number will appear Sending a fax by Direct Keypad Dialing Correct, press MemoryOnce. Redial appears in the display, followed by RedialAutomatic redialing Press RedialError Correction Mode Press Function once Times. DisplayBatch Page Numbering Sending a Fax From Memory Broadcasting sending a fax to multiple destinationsLoad the documents If desired, press RESOLUTION/ to set Broadcasting using a Group KeyWhen you are ready to begin transmission, press Memory Press the appropriate Group KeyStoring numbers in Group Keys Press To program a Group KeyPress To clear a Group Key Press to return to the date and time display Memory transmission If the memory becomes fullUsing FAX Mode Receiving FaxesChanging the number of rings Using TEL Mode Using TEL ModeAnswering on an extension phone connected to the same line Answer the extension phone when it ringsAnswering with the fax’s handset Display shows Receiving and thenOptional Reception Settings Fax Signal ReceivePress once and 7 times Changing the number for remote fax activation Press To select AUTO, or 2 to Reception RatioPress Function once and twice Select 100%Substitute Reception to Memory Select any of the following copy settings as needed Making CopiesExample of two Copies each Three originals If Memory is Full appears When you are ready to begin copying, pressCopy Cut-off Press Once TwiceConnecting an Answering Machine Answering Machine ConnectionChanging the outgoing message Using the Answering Machine ConnectionSet the reception mode to A.M Set your answering machine to auto answerOptional A.M. Mode Settings How answering machine mode operatesQuiet Detect Time Enter a number from 01 to 10, or enter To turn off the functionQuiet Detect Start Time Press Function oncePress once and 6 times On TAD Failure Caller ID Requires Subscription to Service Special FunctionsEnter the three digits of your area code How Caller ID operatesDisplay messages Press Memory to store your area codePress Z twice Voice call Press when you have finished viewing the listViewing the Caller ID list FaxTo delete calls from the Caller ID list Priority CallTo store or clear the number Blocking voice calls Distinctive Ring Requires Subscription to Service Set the reception mode to FAX Blocking Reception of Unwanted Faxes Polling Requesting a Fax Transmission Requesting transmission Being polled polling standbyPolling security Storing fax numbers for polling permission Enter the fax number maximum of 20 digitsEditing and clearing polling permission numbers Press Function once and once Printing ListsActivity Report Press Memory to print the listGroup List Setup ListTelephone Number List Caller-ID ListTransaction Report Headings in the Transaction ReportTransaction Report print condition Auto print-out of Activity Report Press 1 to turn on auto print out, or To turn it offMaintenance Cleaning the MachineCleaning the scanning glass and rollers Maintenance Cleaning the housing Rotating the white rollerImproving Print Quality Aligning the print cartridgeCleaning the print cartridge nozzles Maintenance Wiping the print nozzles and contacts Cleaning the cartridge holder Line error TroubleshootingProblems and Solutions Problem SolutionDialing and transmission problems Trouble- shootingReception and copying problems 100General problems Answering machine connection Messages and Signals Press Start KEY104 Audible signals RecallingClearing Paper Jams Clearing a jammed documentClearing jammed printing paper Flip down the green levers on each side of the white roller108 FCC Regulatory Information A R P Material Safety Data Sheet 2/3 Material Safety Data Sheet 3/3 Quick Reference Guide Sending FaxesGuía de referencia rápida Transmisión de documentosIndex 115116 Page Sharp Corporation