Sharp FO-B1600 operation manual Loading the Document, Other restrictions

Page 36

Loading the Document

Other restrictions

♦The scanner cannot recognize yellow, greenish yellow, or light blue ink.

♦Ink, glue, and correcting fluid on documents must be dry before they pass through the document feeder.

♦All clips, staples, and pins must be removed from documents before loading in the feeder. If these are not removed, they may damage the machine.

♦Documents which are patched, taped, torn, smaller than the minimum size, carbon backed, easily smudged, or have a slick coated surface should be photocopied, and the copy loaded in the feeder.

Loading the Document

Up to 20 letter-size pages, or 5 legal-size pages, can be placed in the feeder at once. The pages will automatically feed into the machine starting from the bottom page.

♦If you need to send or copy more than the maximum number of pages, place the additional pages gently and carefully in the feeder just before the last page is scanned. Do not try to force them in, as this may cause double- feeding or jamming.

♦If your document consists of several large or thick pages which must be loaded one at a time, insert each page into the feeder as the previous page is being scanned. Insert gently to prevent double-feeding.

1

2

Adjust the document guides to the width of your document.

Insert the document face down in the document feeder. The top edge of the document should enter the feeder first.

•READY TO SEND will appear in the display.

34

Image 36

Contents FO-B1600 About the Telephone Consumer Protection ACT Introduction VerticalPaper tray capacity Applicable telephone lineImportant safety information Page Table of Contents Printing Lists Maintenance Look at the Operation Panel Speaker key Hold keyCOPY/HELP key Stop keyInstallation Unpacking ChecklistPoints to keep in mind when setting up AttachmentsRemoving the packing tape Open the print compartment coverConnecting the handset Close the printer coverAttaching the paper trays Installation1 Loading Printing Paper Place Connecting the Power Cord Installing the Print Cartridge Open the operation panelRemove only the tape from the the new cartridge Change Cartridge Installed is new Press OLD if the cartridge you Installed is oldPress NEW if the cartridge you Press Memory Setting the paper size Ink save mode PressPress Once Times Press To turn on ink save mode, orConnecting the Telephone Line Cord Extension phone optional Remove the seal covering the TEL. SET jackConnect the extension phone line to the TEL. SET jack Entering Your Name and Fax Number Enter your fax number by pressing the number keys max digits Setting the Date and Time Press once and 3 timesDaylight Saving Time Setting the Reception Mode Setting the reception modeMode Volume Adjustment Desired volume levelSpeaker Press To selectWhen talking through the handset Press To select HandsetRinger If you selected Ringer OFF OK ? toSize and weight Sending FaxesTransmittable Documents Loading the Document Other restrictionsRemoving a document from the feeder Open the operation panel Remove the documentAdjusting the Resolution and Contrast Resolution settingsContrast settings Press RESOLUTION/ one or more times Load the documentsChanging the default resolution Sending a Fax by Normal Dialing Sending a Fax by Automatic Dialing Sending a Fax by Automatic DialingStoring fax and phone numbers for automatic dialing Rapid KeysPress Function once Once If you know the Speed Dial number thatMemory Editing and clearing auto-dial numbers Return to to store another number, or press to return toDate and time display Press 1 for Edit or 2 for ClearPress Memory Make the desired changes to the name To the date and time displayUsing a Rapid Key for a voice call Rapid Key DialingLoad the documents If desired, press Using a Speed Dial number for a voice call Speed DialingMemory . If not, press Repeat Step Searching for an auto-dial number Press Until the name of the other party appearsDisplay if no name was stored, the number will appear Sending a fax by Direct Keypad Dialing Correct, press MemoryRedial Automatic redialingOnce. Redial appears in the display, followed by Press RedialError Correction Mode Press Function once Times. DisplayBatch Page Numbering Sending a Fax From Memory Broadcasting sending a fax to multiple destinationsBroadcasting using a Group Key When you are ready to begin transmission, press MemoryLoad the documents If desired, press RESOLUTION/ to set Press the appropriate Group KeyStoring numbers in Group Keys Press To program a Group KeyPress To clear a Group Key Press to return to the date and time display Memory transmission If the memory becomes fullUsing FAX Mode Receiving FaxesChanging the number of rings Using TEL Mode Using TEL ModeAnswer the extension phone when it rings Answering with the fax’s handsetAnswering on an extension phone connected to the same line Display shows Receiving and thenOptional Reception Settings Fax Signal ReceivePress once and 7 times Changing the number for remote fax activation Reception Ratio Press Function once and twicePress To select AUTO, or 2 to Select 100%Substitute Reception to Memory Select any of the following copy settings as needed Making CopiesExample of two Copies each Three originals When you are ready to begin copying, press Copy Cut-offIf Memory is Full appears Press Once TwiceConnecting an Answering Machine Answering Machine ConnectionUsing the Answering Machine Connection Set the reception mode to A.MChanging the outgoing message Set your answering machine to auto answerOptional A.M. Mode Settings How answering machine mode operatesQuiet Detect Time Enter a number from 01 to 10, or enter To turn off the functionQuiet Detect Start Time Press Function oncePress once and 6 times On TAD Failure Caller ID Requires Subscription to Service Special FunctionsHow Caller ID operates Display messagesEnter the three digits of your area code Press Memory to store your area codeVoice call Press when you have finished viewing the list Viewing the Caller ID listPress Z twice FaxTo delete calls from the Caller ID list Priority CallTo store or clear the number Blocking voice calls Distinctive Ring Requires Subscription to Service Set the reception mode to FAX Blocking Reception of Unwanted Faxes Polling Requesting a Fax Transmission Requesting transmission Being polled polling standbyPolling security Storing fax numbers for polling permission Enter the fax number maximum of 20 digitsEditing and clearing polling permission numbers Printing Lists Activity ReportPress Function once and once Press Memory to print the listSetup List Telephone Number ListGroup List Caller-ID ListTransaction Report Headings in the Transaction ReportTransaction Report print condition Auto print-out of Activity Report Press 1 to turn on auto print out, or To turn it offMaintenance Cleaning the MachineCleaning the scanning glass and rollers Maintenance Cleaning the housing Rotating the white rollerImproving Print Quality Aligning the print cartridgeCleaning the print cartridge nozzles Maintenance Wiping the print nozzles and contacts Cleaning the cartridge holder Troubleshooting Problems and SolutionsLine error Problem SolutionDialing and transmission problems Trouble- shootingReception and copying problems 100General problems Answering machine connection Messages and Signals Press Start KEY104 Audible signals RecallingClearing Paper Jams Clearing a jammed documentClearing jammed printing paper Flip down the green levers on each side of the white roller108 FCC Regulatory Information A R P Material Safety Data Sheet 2/3 Material Safety Data Sheet 3/3 Quick Reference Guide Sending FaxesGuía de referencia rápida Transmisión de documentosIndex 115116 Page Sharp Corporation