Sharp AR-FX12 Fax send settings, Distinctive ring detection, Disable of fax number direct entry

KEY OPERATOR PROGRAMS

ECM

(This setting is only effective if the other machine

is a G3 machine that supports ECM)

Line conditions can sometimes distort a transmitted fax image. When ECM (Error Correction Mode) is turned on, pages that are distorted are automatically re-transmitted. This setting is initially turned on. If turned off, distorted images will be transmitted without being corrected.

NOTE

If the other machine supports Super G3, ECM will function regardless of the setting.

Fax send settings

The fax transmission settings allow you to adjust certain parameters for sending faxes to better suit your needs.

The fax send settings are as follows: Auto reduction sending setting Rotation sending setting Printing page number at receiver Call timer at memory sending Date/own number print position setting Quick on line sending

Recall in case of line busy

Recall in case of communication error

Distinctive ring detection

This program can only be activated in Canada, Australia, and New Zealand.

If multiple telephone numbers have been assigned to your telephone line, the number called can be identified by its ringing pattern. By using one number for voice calls and another number for faxes, you can tell which type of call you are receiving by the ringing pattern. You can set your machine to automatically receive faxes when your fax number is called by setting the pattern that corresponds to your fax number. (Note that in Canada, six selections are available.) Normally OFF is selected.

Disable of fax number direct entry

When the fax function is enabled, this program is used to prohibit dialing of a destination fax number by direct entry with the numeric keys. To prohibit dialing by direct entry with the numeric keys, touch the checkbox to select it. When this is done, faxes can only be sent to destinations that have been stored, and thus this program can be used to restrict fax destinations and prevent accidental transmission to an incorrect number. The following operations are also prohibited:

Storing one-touch dial numbers

Direct entry of fax numbers when storing a group Direct entry of fax numbers of relay destinations in a relay broadcast memory box

Auto reduction sending setting

This setting lets you select whether to have a transmitted document reduced to match the size of the other machine's printing paper. Auto reduction is normally turned on. If the setting is turned off, documents are sent in their original size. Because the size is not adjusted to match the size of the printing paper, part of the received document may be cut off.

Rotation sending setting

When transmitting a document, this setting allows you to rotate a vertically oriented A4 (8-1/2"x11") document to a horizontal orientation (A4R (8-1/2"x11"R)), rotate a B5R (5-1/2"x8-1/2R") document to B5 (5-1/2"x8-1/2"), or rotate a A5R document to A5. The setting is normally turned on, and documents are rotated counterclockwise. (A4R (8-1/2"x11"R) documents are not rotated.)

KEY OPERATOR PROGRAMS
ROTATION SENDING SETTING					OK
	ORIGINAL		SENDING
	SET		DIRECTION
		A4		A4R

B5R B5B5

A5R A5

Rotation settings can be separately established for different document sizes. To turn off a rotation setting, touch the checkbox of the appropriate setting to remove the checkmark.

8

Printing page number at receiver

This setting lets you select whether page numbers are printed at the top of fax pages by the receiving machine. The normal setting is to have page numbers printed.

8-7