Linksys FENSK05 manual Novell NetWare Setup, Ainstall

NetWare

Novell NetWare Setup

The instructions below cover the following versions of Novell NetWare:

·NetWare workstations for DOS & Windows 3.x

·Client32 for Windows 95 & Windows 98

·3.12, 4.x, and 5.0 NetWare Servers

If you have a version or type of NetWare not shown above, run the README program on the EtherFast Card disk to obtain the installation instructions for your version. See page 10 for more information about the

README.

Installing NetWare Workstations for DOS (6.22 or higher) and Windows 3.x Users

The installation of the EtherFast Card's Novell worksta- tion drivers is accomplished with a program on the EtherFast Card disk called DIAG. DIAG will copy the appropriate network drivers to your computer, generate a NetWare NET.CFG file, and automatically update your AUTOEXEC.BAT and CONFIG.SYS system files.

DIAG also comes with a built-in diagnostic feature that allows you to test the EtherFast Card's functionality at any time. For more instructions on testing the card, see the Troubleshooting section at the end of this guide.

1.Start up your computer in DOS. Insert the EtherFast Card disk into drive A.

2.From the DOS command prompt (C:\>), type the fol- lowing commands one-by-one. Press the Enter key after each command:

a:install

35