Motorola Communications Gateway manual Before You Begin

Page 12

Introduction

Before You Begin

Installation & Configuration

Troubleshooting

FAQ

Glossary

License

Before You Begin

Before you begin the installation, check that you received the following items with your Motorola Communications Gateway:

Item

Power cord

10/100Base-T Ethernet cable

USB cable

Phone wire

Motorola

Communications

Gateway CD-ROM

Description

Connects to the AC electrical outlet

Connects to the Ethernet port

Connects to the USB port

Connects a telephone line

Contains the User Guide, USB driver, and other items supporting your Communications Gateway

Home	Print	X
		Exit

You will need 75-ohm coaxial cable (coax) with F-type connectors to connect your Communications Gateway to the nearest cable outlet. If a TV is connected to the cable outlet, you may need a 5 to 900 MHz RF splitter to use both the TV and the Communications Gateway. Both the coaxial cable and the RF splitter are readily available at consumer electronic stores.

7	Communications Gateway User Guide

Image 12

Contents Communications Gateway User Guide Home Print Iii Contents Replacing the Battery Wall Mounting Troubleshooting Introduction Telephone CommunicationsHigh-Speed Internet Access FasterTop and Front Panel Light DescriptionTop and Front Panel Connector Panel Battery Compartment Item DescriptionBefore You Begin Precautions Always make the wall connection firstPrecautions Signing Up for Service Cable Data ServiceTelephone Service Computer System Requirements Ethernet CardUSB Connection Installation and Configuration Overview Hand-tighten the connectors to avoid damaging them Cabling and Startup for a Single UserCabling and Startup for a Single User Cabling and Startup for a Single User Cabling and Startup for a Single User Cabling and Startup for a Single User Immediately plug the power cord into the electrical outlet To telephone lines Configure TCP/IP following one Setting Up a USB Driver Setting Up a USB Driver in Windows 98 SE Setting Up a USB Driver in Windows 98 SE Select The updated driver... and click Next Setting Up a USB Driver in Windows 98 SE Setting Up a USB Driver in Windows Setting Up a USB Driver in Windows Setting Up a USB Driver in Windows Setting Up a USB Driver in Windows Setting Up a USB Driver in Windows Me Setting Up a USB Driver in Windows XP Configuring TCP/IP Configuring TCP/IP in Windows 95, 98, or Me Configuring TCP/IP in Windows 95, 98, or Me Click Obtain an IP address automatically Configuring TCP/IP in Windows 2000 or XP Configuring TCP/IP in Windows 2000 or XP Configuring TCP/IP in Windows 2000 or XP Configuring TCP/IP in Windows 2000 or XP Verifying the IP Address in Windows 95, 98, or Me Verifying the IP Address in Windows 2000 or XP Verifying the IP Address in Windows 2000 or XP Cabling for Multiple Users Ethernet and USBEthernet Replacing the Battery Replacing the Battery Replacing the Battery Replacing the Battery Replacing the Battery Wall Mounting Print the Wall Mounting Template on If necessary, seat an anchor in each hole 125.0 mm Inches Troubleshooting Problem Possible SolutionsCannot send or receive data Lights and Error Conditions Light During Startup During Normal OperationRemoving the USB Driver from Windows 98 or Me Troubleshooting Troubleshooting Troubleshooting Click Settings Removing the USB Driver from Windows 2000 or XPSelect Uninstall/Unplug a device and click Next Troubleshooting Troubleshooting Troubleshooting Click Remove Driver Contact Us Frequently Asked Questions What is high-speed cable Internet access?What are CableLabs Certified, Docsis and EuroDOCSIS? What type of technical support is available? Glossary Coaxial cable coaxType connector Pstn VoIP Software License Government Restricted Rights 493049-001 02MGBI English