Motorola Communications Gateway manual Replacing the Battery

Introduction Before You Begin

Installation & Configuration

Troubleshooting FAQ Glossary License

First, slide the battery

under the hook

Then rotate the battery

under the snaps

Replacing the Battery, continued

10On a slight angle, gently slide the top-right corner of the battery under the battery hook as shown at left.

While you rotate the battery into position, to avoid pinching the wires between the battery and the base, be sure the battery wires are not under the battery. Pinching the wires between the battery and the base:

■May damage the wires

■Will cause the battery to seat incorrectly

11Rotate the battery into position under the battery snaps as shown by the arrow at left. When the battery is fully seated, the snaps engage the battery base.

12Carefully replace the battery compartment cover. Do not force the cover closed. If the battery compartment cover does not close easily, check that:

■The power cord is positioned correctly in its opening

■The battery is correctly seated (you performed steps 14 to 15 correctly)

Home	Print	X	48	Communications Gateway User Guide
		Exit